6013 6024
GENERAL
Thank you for purchasing our lighting fixture.
Please clean with a soft, dry cloth ONLY! Do not use cleansers.
www.hudsonvalleylighting.com/mitzi
1. To ensure the success of the fixture installation, the following instructions and diagram(s) should be read and
understood.
2. All electrical connections must be made in accordance with the National Electric code and local codes and
ordinances. If you are uncertain of the methods of installing electrical wiring and lighting fixtures secure the
services of a qualified licensed electrician.
TOOLS NEEDED
Blade screwdriver, phillips screwdriver, slip joint pliers or small adjustable wrench, wire cutter/stripper, electrical
current tester, stepladder and electrical tape.
INSTALLATION PREPARATION
1. TURN OFF THE ENTIRE ELECTRICAL CIRCUIT TO WHICH THE LIGHTING FIXTURE IS
TO BE ATTACHED. Turn circuit breaker to the “off” position or completely remove the fuse controlling the
circuit.
2. If an existing fixture is being replaced, remove it and note to which of the wires in the outlet box the fixture
was attached. DO NOT SEPARATE MULTIPLE TWISTED WIRES THAT MAY BE IN THE BOX.
DO NOT DAMAGE THE INSULATION OF OLDER WIRING. In regular circumstances the BLACK
wire will be the “Hot” lead and the WHITE wire will be the “Neutral” or “Common” lead. A GREEN or BARE
COPPER wire is the “Ground”. In older buildings it is always good practice to reconfirm the polarity of the
wiring.
3. This fixture is designed to be mounted on an octagon box. The box must be securely mounted to the
structure of the building.
FIXTURE INSTALLATION
1.Remove the fixture and parts bag(s) from the carton. Before discarding the carton, double check packing to make
certain that all parts are found.
2. Using the mounting plate mark holes on the wall for the anchors. Drill holes on the wall and push the anchors into
the wall. Place the mounting plate back over the wall and secure with the screws into each anchor, and outlet box.
3. Fasten the bare ground wire to the green or bare copper wire in the outlet box or the green screw on the
crossbar.
NEVER FASTEN THE GROUND WIRE TO THE BLACK OR "HOT" WIRE ! FAILURE TO
FOLLOW THIS INSTRUCTION COULD RESULT IN SERIOUS INJURY OR DEATH !
4. Fasten the fixture lead with the ridge(s) to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut) Sterting about 1" below the fastener, tightly wrap the
connetion with electrical tape so that the tape seals the end of the fastener. Make sure that there is no exposed
wire or strands that could cause a dangerous short circuit !
5. Connect the black fixture wires to the black wire in the outlet box. Fasten the
joined wires as in step 4.
6. Place the back plate with alabaster shade over the mounting plate and fasten it by set screws.
7. Attach the alabaster panels to the back plate then secure with screws.
8. Place the top cover to the back plate and fasten it with long screw .
9 .Lift the bottom cover to the back plate and fasten it with long screw .
10.Insert the glass through the top cover to the bottom of back plate .
11. Restore power to circuit at breaker or fuse box.
DIMMING
The fixture can be controlled by a wall dimming device. Only use Triac/electronic dimmer. Make sure the carton is
marked for use with LED compact fluorescent-incandescent light source only. These can be provided by your local
electrical distributor, home center, or hardware store.
Loading...