Hudson Valley 632 User Manual

631 &632

Electrical tape

Approved fastener

(Wire nut)

Hudson Valley Lighting, Inc.

P.O. Box 7459
106 Pierces Road
Newburgh, NY 12550
[phone]

www.hudsonvalleylighting.com

GENERAL

1. To ensure the success of the fixture installation, the following
instructions and diagram(s) should be read and understood.

2. All electrical connections must be made in accordance with the National
Electric code and local codes and ordinances. If you are uncertain of the
methods of installing electrical wiring and lighting fixtures secure the
services of a qualified licensed electrician.

3. TOOLS NEEDED: Blade screwdriver, philliips screwdriver, slip joint
pliers or small adjustable wrench, wire cutter/stripper, electrical current
tester, stepladder and electrical tape. NOTE: The important safeguards
and instructions outlined on this sheet are not meant to cover all possible
conditions and situations that may occur. It must be understood that
common sense, caution and care are factors that cannot be built into any
product.
Caution and care must be supplied by the person(s) installing, operating
and maintaining this lighting fixture.

INSTALLATION PREPARATION

1. TURN OFF THE ENTIRE ELECTRICAL CIRCUIT TO WHICH THE

LIGHTING FIXTURE IS TO BE ATTACHED. Move the appropriate

circuit breaker to the “off position or completely remove the fuse controlling

the circuit.

2. If an existing fixture is being replaced, remove it and note to which of the
wires in the outlet box the fixture was attached. DO NOT SEPARATE

ANY OTHER WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE

THE INSULATION OF OLDER WIRING. In regular circumstances the

BLACK wire will be the “Hot” lead and the WHITE wire will be the “Neutral”
or “Common” lead. A GREEN or BARE COPPER wire is the “Ground”. In

older buildings it is always good practice to reconfirm the polarity of the
wiring.

3. This fixture is designed to be mounted on a standard round or octagon
box. The box must be securely mounted to the structure of the building.

FIXTURE INSTALLATION

1. Remove the fixture, shades and parts bag(s) from the carton. Before
discarding the carton, double check packing to make certain that all parts
are found.

2. Remove the 3 screws holding the mounting plate to the fixture.

3. Pull the wires in the outlet box through the center hole of the mounting
plate. Attach the mounting plate to the outlet box. (The green ground screw
should face out). Align the mounting plate so the bottom screw hole is
exactly at the bottom.

4. Fasten the green fixture wire to the green or bare copper wire in the box
or fasten it to the mounting plate with green screw provided.

NEVER FASTEN THE GROUND WIRE TO THE BLACK OR “HOT”

WIRE! FAILURE TO FOLLOW THIS INSTRUCTION COULD RESULT

IN SERIOUS INJURY OR DEATH !

5. Fasten the white fixture wire to the white wire in the outlet box. Fasten
the wires to together with an approved fastener (wire nut).

Starting about 1” below the fastener, tightly wrap connection with electrical

tape so that the tape seals the end of the fastener.
Make sure that there is no exposed wire or strands that could cause a
dangerous short circuit!

6. Connect the black fixture wires to the black wire in the outlet box. Fasten
the joined wires as in step 5.

7. Place the fixture over the mounting plate. and fasten it in place with the
3 screws.

8. Place the rings onto the top and bottom of the shade(s)

9. Place the shade(s) onto the socket cover(s).

10. Install the lamp(s) light bulb(s).
NOTE: This fixture is rated for 60 watt type B, BA, C or CA lamp(s).

DO NOT EXCEED RECOMMENDED WATTAGE !

11. Restore power to circuit at breaker or fuse box.

glass

Cross Bar

Ground

Screw

Screw

shade

lamp

Outlet box