Hudson Valley 2055 User Manual

Installation Instructions

General

Assembling the Fixture

Carefully remove the fixture from the carton, and check

that all parts are included, as shown in figure. Be careful
not to misplace any of the screws or parts which are
needed for installing the fixture.

1 Position crossbar on wall. Align slotted hole in

crossbar to threaded holes in Outlet Box. Attach
with two screws (Screws not Provided.)

2 Secure crossbar to the wall through the key hole

each end.

3 If the GREEN GROUNDING SCREW is supplied

with a WASHER. Slip the WASHER over the GREEN
GROUNDING SCREW. With the cupped side of the
WASHER facing the head of the SCREW. Screw into
the small threaded hole in the CROSSBAR. Do not
tighten.

Connecting the Wires

Connecting the wires to the connectors is shown in
figure 2

1 Attach the outlet ground wire(green wire or bare

copper only) along with the fixture ground wire
(if present) to the green grounding screw. Wrap the
wire(s) around the green ground screw between the
washer and the head of the screw. Tighten the screw.
If your wall mounted fixture does not have a ground
wire, it will still be grounded by metal to metal contact
with the crossbar.

2 Place the white wires from the fixture evenly against

the white wire from the Outlet Box. and then twist
together the bare parts of the wires.

3 Fit the connector over the twisted wires. and screw

the connector in place until you feel a firmness.

4 Try gently to pull the connector off the wires. If

you can pull the connector off, carefully redo steps
1 and 2 above. and check again for a firm connection

5 Connect the black wires in the same manner.

6 After the wires are connected, tuck them carefully

inside the Outlet Box. And then slip the canopy over
the crossbar and lock against the wall by screwing .
The finial onto the protruding nipple.

Warning

Be sure the electricity to the wires you are working on
is shut off-either the Fuse removed or the Circuit
Breaker set at Off.

Figure 2-Wire Connectors

Nipple