Hubsan HT006 User Manual

®
HT006 User Manual
HT006 GPS WATCH
Version 2.0
Connect the GPS watch with the provided Micro USB charging cable to a 5V adapter or PC terminal to charge. When charging, the LED right above the Micro USB port on the unit stays solidly lit; when charging is complete, the LED will extinguish itself. In the latter case, please disconnect the watch and cable. In general, approximate charging time is 40 minutes.
Charging the HT006
Product Description
The Hubsan HT006 is a remote-control watch equipped with GPS. It may be paired with a Hubsan aircraft for flight and is suitable for any Hubsan equipped with a 2.4G flight control signal and GPS. Recommended flight distance is 60 meters.
Step 1
Place the aircraft on a flat and open floor/surface, with the head facing away from the user.
Step 2
Pair the watch with the aircraft.
The watch must be paired with the aircraft for the units to operate properly.
The pairing steps are as follows:
1. Please begin with the watch powered off. Press the power and camera buttons to enter pairing mode. Notice all 5 LEDs on the unit flash simultaneously.
Basic Flight Operation
Calibration steps:
Make sure the aircraft is resting on a flat and level surface. At this point, its 4 LEDs will transition from flashing simultaneously to flashing clockwise. Start compass calibration.
If after initialization, the aircraft and watch have not paired for some time, please restart both units.
Step 3
Compass calibration
The compass must be calibrated every time the aircraft is powered on. The compass is susceptible to interference by other electronic equipment, magnetic interference and metal, which can lead to erratic behavior and loss of control. Regular calibration helps keep the compass and its readings accurate.
2. Connect the aircraft to its battery; make sure the two are very close to each other. Allow the watch and aircraft to pair; the watch LEDs will stop flashing to indicate a successful pairing.
3. After the pairing is successful, aircraft and watch LEDs should be solidly lit. While in GPS mode, the aircraft and watch LEDs flash slowly.
Do not calibrate the compass in areas with strong magnetic interference, magnetic objects or structures, in areas with underground wiring, large pieces of metal or large metal structures.
Do not carry ferromagnetic materials while calibrating the compass, such as keys, cell phones, etc.
Horizontal calibration
1) Horizontal calibration Slowly rotate the aircraft on the horizontal
plane. The LEDs should be flashing clockwise; proceed to step 2 when the LEDs start flashing in vertical pairs, alternately.
vertical calibration
2) Vertical calibration Point the head of the aircraft downwards
and rotate the aircraft in place until the LEDs cease to flash and stay solidly lit.
Manual calibrations: Horizontal/Gyro calibration: Simultaneously long press the Camera and Orbit keys for 3 seconds to calibrate the aircraft gyro sensor. Make sure that the aircraft is on a smooth and level surface. Compass calibration (manual): Simultaneously long press the Video and Orbit keys for 3 seconds to manually initiate a compass calibration.
Loading...
+ 11 hidden pages