Hubbell Lighting BULLET LGT, BDP6UQ-M User Manual

INSTALLATION INSTRUCTIONS

See warnings on carton.

WARNINGS:

• Disconnect power before installation or servicing.

• Install, operate and maintain to meet all applicable codes.

• Supply voltage must be 120V.

• Protect all wiring connections with approved insulators (by others).

GENERAL INFORMATION:

• Junction box (by others) must be weatherproof, suitable for wet locations.

• Use a waterproof pipe joint compound (by others) for all entries into junction box.

• Plug all unused entries into junction box.

• Knuckle threads are ½-14 NPS.

• Allow 6 inches min. supply wire outside of junction box.

• Lamp is included with fixture.

Fixture

Black White

Ground

Line (HOT)

Neutral

Green/Ground

WIRING DIAGRAM

1. Install lamp.

2. Install gasket (3), lens (4) and lens ring (5).

3. Thread knuckle (2) into junction box cover and tighten lock nut (1).

4. Make wiring connections.

5. Mount cover to junction box.

6. Tighten knuckle hardware after aiming.

268-1204-9901

Specifications and Main Features