Hubbell lighting 3120-X, RPA-90-X User Manual

COVER

ALL

UN-USED

HOLES

INSTALLATION INSTRUCTIONS

FOR RPA-90-X & RPA-3120-X

POLE CAP

FOR ARM INSTALLATION, SEE INSTRUCTIONS

SHIPPED WITH FIXTURE OR ARM (MSV ARM SHOWN)

ROUND POLE ADAPTER

RSD-04-X REQUIRED

4 - 1/16"

POLE ADAPTER (4.026" ID)

SET-SCREWS

EXISTING POLE

• Rotate adapter to desired orientation.

• Insure that adapter is centered on pole and top is level.

• Tighten equally the (3) adapter set-screws.

• To insure that the adapter with attached fixtures does not rotate under high wind conditions, the following additional
steps are recommended:

• Remove (1) set-screw.

• Using a 5/16" diameter drill, use the tapped hole in the adapter that the set-screw was removed from as a guide and

• drill a shallow hole in the existing pole.

• Replace set-screw and re-tighten.

268-1188-9901