Hubbell Electric Heater F60 Installation Manual

OPERATING AND MAINTENANCE MANUAL FOR

INSTANTANEOUS STEAM FIRED WATER

HEATER

ELECTRIC HEATER COMPANY

BASE MODEL “ F ”

Edition 2013

HUBBELL

ELECTRIC HEATER COMPANY

P.O. BOX 288

STRATFORD, CT 06615

PHONE: [phone]
FAX: [phone]

INTERNET: http://www.hubbellheaters.com/

-- IMPORTANT --

Always reference the full model number and serial number when calling the factory.

WARNING / CAUTION

1. FLUIDS UNDER PRESSURE MAY CAUSE INJURY WHEN RELEASED.

Always shut off all incoming and outgoing valves and carefully decrease all trapped
pressures to zero before opening any covers, piping or gauge connections, etc.

HOT WATER OR HOT SURFACES CAN CAUSE SEVERE BURNS. Wear

safety goggles and protective gloves when carrying out maintenance procedures
involving the heater and/or when removing and accessories from the heater. Shield
your eyes and body to protect from spray when opening a relief valve.
Due to the rigors of transportation, all connections should be checked for tightness before
heater is placed in operation.

2. Safety relief valve must be installed according to local plumbing codes.

KEEP AWAY FROM LIVE ELECTRICAL CIRCUITS.
Do not perform any maintenance, make any adjustments, or replace any components
inside the control panel with the high voltage power supply turned on. Under certain
circumstances, dangerous potentials may exist even when the power supply is off. To
avoid casualties, always turn the power supply safety switch to off, turn the charge or
ground the circuit before performing any maintenance or adjustment procedure.
Generalized instructions and procedures cannot anticipate all situations. For this reason,
only qualified installers should perform the installations. A qualified installer is a person
who has licensed training and a working knowledge of the applicable codes regulation,
tools, equipment, and methods necessary for safe installation of a steam fired water
heater. If questions regarding installation arise, check with your local plumbing and
electrical inspectors for proper procedures and codes.

SECTION TITLE PAGE No.

I GENERAL DESCRIPTION AND CONSTRUCTION 6

II INSTALLATION 8

III START-UP AND PROCEDURE 11

IV MAINTENANCE 13

V TROUBLESHOOTING 20

VI MISCELANEOUS CHARTS AND FORMULAS 23

2