Hubbell SUPER QUADCAB WALL MOUNT CABINET Installation Instructions
®
Hubbell Premise Wiring Instruction Sheet
SUPER QUADCABTM WALL MOUNT CABINET
Parts List
Item Description Qty
1 Rear Section 1
2 Center Section w/ Front Door 1
3 Hinge Pin & Retaining Clip 2
1
Control No. Page of
77394801 1 1
Rev. Date:
E 3/28/05
2
CAUTION: Failure to follow these instrutions could result in equipment damage or personal injury.
Notes:
• Please read entire instructions before assembling.
• Compare contents with above parts list to ensure that you have received all parts.
3
SHT: 2 OF 2 DR. NO. 773948 REV E
1 MOUNTING INSTRUCTIONS:
CAUTION: The Super QuadCab is able to carry high loads. You
must verify that your mounting hardware and wall are able to
support a load of 400 lbs. plus the weight of the cabinet.
CAUTION: Consult all applicable local codes and regulations to
determine proper mounting methods. Use of a certif ed professional engineer is recommended to verify installation.
DO NOT USE DRYWALL SCREWS OR TOGGLE BOLTS.
1.1 Holes for 3/8” and #8 counter sink hardware, spaced on 16”
centers, are provided in the rear of the cabinet. (see f gure 1)
1.2 Install required hardware at top keyhole locations so that rear
door can be hung.
1.3 Determine required cabinet opening direction. Rotate rear
door to place hinges on the proper side.
1.4 Hang rear door at top keyhole positions and install remaining
hardware.
2 CABINET ASSEMBLY
2.1 Align main body of cabinet so that hinge-pin holes line up
3"
TYP
H
FIGURE 1
16"
3/8"
#8
COUNTERSINK
Series "H"
2' 17.77"
3' 29.77"
4' 41.77"
3 ROUTING CABLE:
3.1 Leave service loops of 12" and tie entering cable as shown.
3.2 Route cable from front to rear along channel and tie off as
shown.
Loading...