Page 1
TM TM
TM
TM TM
10 10
AMP LINKAMP LINK
10
AMP LINK
10 10
AMP LINKAMP LINK
INSTALLATION INSTRUCTIONS
GENERAL INFORMATION
1. NOTICE: For installation by a qualified electrician in accordance with national and local electrical codes and the following instructions.
2. CAUTION: RISK OF ELECTRIC SHOCK. Disconnect power before installing. Never wire energized components.
3. NOT FOR INTERRUPTING CURRENT. DO NOT CONNECT OR DISCONNECT UNDER LOAD.
4. CAUTION: To ensure seal of enclosure to Type ratings:
a) Mounting gasket MUST be in place on receptacle and fully seated against the mounting surface.
b) Locknut MUST be fully tightened against panel interior.
c) Coupling nut MUST be fully tightened against mating connector
d) For fixed installations, coupling nuts must be wrench tight - 1/4 turn beyond hand tight.
This receptacle is rated Enclosure Types 4, 4X, 12, 13 when fully connected to a LinkosityTM plug, having an equivalent Enclosure Type rating. Receptacles enclosure may affect
Enclosure Type designation.
5. Check that the devices’ Enclosure Type Rating and electrical ratings are suitable for the application.
INSTALLATION & USE
1. Recommended panel cutout diameter is 0.830 (21.1 mm) for receptcles with ½ NPT thread.
2. “O” ring or flange gasket to be between the flange of shell and the panel.
3. CAUTION: Mounting means not grounded. Assembly of receptacle to panel does
4. TAKE CARE IN TERMINATIONS THAT THERE ARE NO STRAY WIRE STRANDS. DO NOT TIN WIRES.
5. Position receptacle assembly into panel cutout.
6. Complete installation by tightening lock nut.
7. Do not connect to power before conducting the following electrical tests:
• Test continuity of wiring to verify correct polarity and phasing.
• Measure insulation resistance to be sure the system does not have any short circuits or unwanted grounds.
8. CAUTION: If any parts of the receptacle appear to be missing, broken or show signs of damage: DISCONTINUE USE IMMEDIATELY! Replace damaged component. Failure to could cause
serious injury or equipment damage.
OSITYOSITY
OSITY
OSITYOSITY
NOT ground receptacle. Where applicable CONNECT GREEN WIRE TO EQUIPMENT GROUND.
RECEPTRECEPT
RECEPT
RECEPTRECEPT
AA
CLESCLES
A
CLES
AA
CLESCLES
CONTACT LOCATIONS FOR LINKOSITYTM RECEPTACLES
MALE FACE VIEW
2P 3P 4P 5P 6P
7P
LinkosityTM is a trademark of Lockheed Martin.
Wiring Device-Kellems
Hubbell Incorporated (Delaware)
185 Plains Road
Milford, CT 06460-8897
(203) 882-4800
8P
9P
PD2039 (Page 1) 12/09
10P
12P
CONTACT LOCATIONS FOR LINKOSITYTM RECEPTACLES
FEMALE FACE VIEW
2P 3P 4P 5P 6P
8P 10P
9P7P
12P
®
Loading...