Page 1
TMTM
TM
TMTM
LINKLINK
LINK
LINKLINK
GENERAL INFORMATION
1. NOTICE: For installation by a qualified electrician in accordance with national and local electrical codes and the following instructions.
2. CAUTION: RISK OF ELECTRIC SHOCK. Disconnect power before installing. Never wire energized components.
3. NOT FOR INTERRUPTING CURRENT. DO NOT CONNECT OR DISCONNECT UNDER LOAD.
4. CAUTION: To ensure seal of enclosure to Type ratings, tighten coupling nut firmly against mating connector. This connector
5. Check that the devices’ Enclosure Type Rating and electrical ratings are suitable for the application.
INSTALLATION & USE
1. Do not connect to power before conducting the following electrical tests:
2. CAUTION: If any parts of the connector or cable appear to be missing, broken or show signs of damage: DISCONTINUE USE
3. Coupling nuts to be hand tight.
4. For fixed applications, coupling nuts must be wrench tight - 1/4 turn beyond hand tight.
OSITYOSITY
OSITY
OSITYOSITY
is rated Enclosure Types 4, 4X, 12, 13 when fully connected to a mating LinkosityTM connector or receptacle having an
equivalent Enclosure Type rating.
• Test continuity of wiring to verify correct polarity and phasing.
• Measure insulation resistance to be sure the system does not have any short circuits or unwanted grounds.
IMMEDIATELY! Replace damaged component. Failure to could cause serious injury or equipment damage.
10 10
10
10 10
AMP POAMP PO
AMP PO
AMP POAMP PO
INSTALLATION INSTRUCTIONS
WER SUPPLWER SUPPL
WER SUPPL
WER SUPPLWER SUPPL
Y CORDS Y CORDS
Y CORDS
Y CORDS Y CORDS
AND AND
AND
AND AND
TEE'STEE'S
TEE'S
TEE'STEE'S
CONTACT LOCATIONS FOR LINKOSITYTM CONNECTORS
MALE FACE VIEW
2P 3P 4P 5P 6P
7P
LinkosityTM is a trademark of Lockheed Martin.
Wiring Device-Kellems
Hubbell Incorporated (Delaware)
185 Plains Road
Milford, CT 06460-8897
(203) 882-4800
PD2038 (Page 1) 3/09
8P
9P
10P
12P
WIRING CODE FOR LINKOSITYTM CONNECTORS
FEMALE FACE VIEW
2P 3P 4P 5P 6P
8P 10P
9P7P
12P
®
Loading...