Page 1
INSTALLATION, OPERATION &
MAINTENANCE DATA SHEET
“KFWB--SLIPFITTER 2”-2.5” HEAVYDUTY”
KFWB--SLIPFITTER 2-2.5” HEAVYDUTY
CAUTION:
Before installing, make sure you are compliant with area classications, failure to do so may result in bodily injury,
death and property damage. Do not attempt installation until you are familiar with the following procedures. All
installation must comply with the applicable Electrical Code.
Make sure that the circuit is de-energized before starting installation or maintenance.
Verify that the installation is grounded. Failure to ground will create electrical shock hazards, which can cause
serious injury and or death.
Technical information, advice and recommendations contained in these documents is based upon information
that Killark believes to be reliable. All the information and advice contained in these documents is intended for
use only by persons having been trained and possessing the requisite skill and know-how and to be used by
such persons only at their own discretion and risk. The nature of these instructions is informative only and does
not cover all of the details, variations or combinations in which this equipment may be used, its storage, delivery,
installation, check out, safe operation and maintenance. Since conditions of use of the product are outside of the
care, custody and control of Killark, the purchaser should determine the suitability of the product for his intended
use, and assumes all risk and liability whatsoever in connection therewith.
3940 Dr. Martin Luther King Drive
St. Louis, MO 63113
P/N KIL00921424 FORM NO. K1424 12/13 ERO-6-103-13
Page 1 of 2
Page 2
Before installing, be sure to read and be familiar with
the following instruction procedures. All installations
must comply with applicable local, National Electrical
Codes and/or Canadian Electrical Code.
1. DIRECTIONS FOR INSTALLATION
WARNING: Electrical power supply MUST BE OFF
Before and during installation and maintenance.
1. Assemble bracket (1) to bracket (2) nger tight
with ¾” diameter bolt (4), lock washer and nut.
2. Bracket Assembly mounting:
For Vertical or Horizontal Pole Mounting: Secure
bracket assembly with 3/8” U-bolt clamps, lock
washers and nuts.
For Wall Mounting: Secure bracket assembly
with four 3/8” dia. hardware (by others).
3. Secure xture yoke (3) (by others) to bracket
assembly with two ½” bolts, lock washers and
nuts.
4. Aim xture.
5. Install and tighten ¼” screw, lock washer and
at washer to secure aiming position.
6. Tighten bolt (4).
3940 Dr. Martin Luther King Drive
St. Louis, MO 63113
P/N KIL00921424 FORM NO. K1424 12/13 ERO-6-103-13
Page 2 of 2
Loading...