Page 1
INSTALLATION, OPERATION &
MAINTENANCE DATA SHEET
For GEC series Outlet Bodies
GEC SERIES OUTLET BODIES
CAUTION:
Before installing, make sure you are compliant with area classications, failure to do so may result in bodily injury,
death and property damage. Do not attempt installation until you are familiar with the following procedures. All
installation must comply with the applicable Electrical Code.
Make sure that the circuit is de-energized before starting installation or maintenance.
Verify that the installation is grounded. Failure to ground will create electrical shock hazards, which can cause
serious injury and or death.
IMPORTANT:
Please read these instructions carefully before installing or maintaining this equipment. Good electrical practices
should be followed at all times and this data should be used as a guide only.
Technical information, advice and recommendations contained in these documents is based upon information
that Killark believes to be reliable. All the information and advice contained in these documents is intended for
use only by persons having been trained and possessing the requisite skill and know-how and to be used by
such persons only at their own discretion and risk. The nature of these instructions is informative only and does
not cover all of the details, variations or combinations in which this equipment may be used, its storage, delivery,
installation, check out, safe operation and maintenance. Since conditions of use of the product are outside of the
care, custody and control of Killark, the purchaser should determine the suitability of the product for his intended
use, and assumes all risk and liability whatsoever in connection therewith.
3940 Dr. Martin Luther King Drive
St. Louis, MO 63113
P/N KIL00921457 FORM NO. K1457 ERO-1-004-15 10/15
Page 1 of 2
Page 2
PART I : Normal Application : For use in Class I,
Groups C & D, Class II, Groups E, F & G and Class III
Hazardous Locations.
The GEC series outlet bodies standard application:
the proper assembly of the cover and body for
Groups C & D requires minimum of six threads (turns)
engagement to comply with the UL/CSA Standards
requirements.
PART II : Extended Application : For use in Class I,
Groups B, C & D, Class II, Groups E, F & G and Class
III Hazardous Locations. Enclosure Type 3, 4 & 4X
as dened by the Canadian Electrical Code and the
National Electrical Code.
The design of the GEC series outlet bodies has been
updated with additional features.
The proper assembly of the cover and body, requires
minimum of eight (8) threads (turns) engagement, to
be suitable for Class I, II, III Groups B, C, D, E, F and
G. In addition, when supplied with an o-ring, the unit
is qualied as NEMA Type 3, 4 & 4X for outdoor use.
It is the responsibility of the installer to conrm that
the above thread engagement is met, when installing
the unit in Group “B” Hazardous Classied Locations.
3940 Dr. Martin Luther King Drive
St. Louis, MO 63113
P/N KIL00921457 FORM NO. K1457 ERO-1-004-15 10/15
Page 2 of 2
Loading...