Page 1
INSTALLATION, OPERATION &
MAINTENANCE DATA SHEET
DURALOY 7 SERIES
DURALOY 7 SERIES
CAUTION:
Before installing, make sure you are compliant with area classications, failure to do so may result in bodily injury,
death and property damage. Do not attempt installation until you are familiar with the following procedures. All
installation must comply with the applicable Electrical Code.
Make sure that the circuit is de-energized before starting installation or maintenance.
Verify that the installation is grounded. Failure to ground will create electrical shock hazards, which can cause
serious injury and or death.
IMPORTANT:
Please read these instructions carefully before installing or maintaining this equipment. Good electrical practices
should be followed at all times and this data should be used as a guide only.
Technical information, advice and recommendations contained in these documents is based upon information
that Killark believes to be reliable. All the information and advice contained in these documents is intended for
use only by persons having been trained and possessing the requisite skill and know-how and to be used by
such persons only at their own discretion and risk. The nature of these instructions is informative only and does
not cover all of the details, variations or combinations in which this equipment may be used, its storage, delivery,
installation, check out, safe operation and maintenance. Since conditions of use of the product are outside of the
care, custody and control of Killark, the purchaser should determine the suitability of the product for his intended
use, and assumes all risk and liability whatsoever in connection therewith.
3940 Dr. Martin Luther King Drive
St. Louis, MO 63113
P/N KIL00921430 FORM NO. K1430 01/14 ERO-0-001-14
Page 1 of 2
Page 2
Before installing, be sure to read and be familiar with
the following instruction procedures. All installations
must comply with applicable local, National Electrical
Codes and/or Canadian Electrical Code.
The Duraloy 7 Series consists of 10 separate models,
either Aluminum or Iron type. The function of the
conduit body is to provide access to conductors for
pulling, splicing and maintenance per NEC regulation
standards.
DIRECTIONS FOR INSTALLATION
WARNING: Electrical power supply MUST BE OFF
Before and during installation and maintenance.
1. Do not use this equipment for any application other
than the intended use as specied per certied UL
or CSA les and their ratings.
2. Turn OFF the supplying circuit before beginning
installation or performing any maintenance. With
power turned off, service must be done in nonhazardous atmosphere.
3. If a gasket is required, ensure tight seal between
conduit body and cover.
4. The connecting conduit and ttings shall be made
wrench tight to prevent sparking when fault current
ows through the conduit system. The threaded
connection must exist to ensure the integrity of the
conduit system.
3940 Dr. Martin Luther King Drive
St. Louis, MO 63113
P/N KIL00921430 FORM NO. K1430 01/14 ERO-0-001-14
Page 2 of 2
Loading...