Page 1
FORM K1158 - INSTALLATION DATA SHEET
MOUNTING PAN KEY FOR B7C CIRCUIT BREAKER
(100 amp max. Circuit Breakers)
ENCLOSURES
CATALOG NO. B7CA
MOUNTING PAN KEY FOR B7C CIRCUIT
BREAKER ENCLOSURES
CAUTION:
Before installing, make sure you are compliant with area classications, failure to do so may result in bodily injury,
death and property damage. Do not attempt installation until you are familiar with the following procedures. All
installation must comply with the applicable Electrical Code.
Make sure that the circuit is de-energized before starting installation or maintenance.
Verify that the installation is grounded. Failure to ground will create electrical shock hazards, which can cause
serious injury and or death.
Technical information, advice and recommendations contained in these documents is based upon information
that Killark believes to be reliable. All the information and advice contained in these documents is intended for
use only by persons having been trained and possessing the requisite skill and know-how and to be used by
such persons only at their own discretion and risk. The nature of these instructions is informative only and does
not cover all of the details, variations or combinations in which this equipment may be used, its storage, delivery,
installation, check out, safe operation and maintenance. Since conditions of use of the product are outside of the
care, custody and control of Killark, the purchaser should determine the suitability of the product for his intended
use, and assumes all risk and liability whatsoever in connection therewith.
3940 Dr. Martin Luther King Drive
St. Louis, MO 63113
P/N 00912091 FORM K1158 07/12 ECO-5-029-12
Page 1 of 2
Page 2
CIRCUIT BREAKER
MANUFACTURER
GENERAL ELECTRIC E150-FRAME TEB, TED, THED, TEL 8-32 X 4
ITE-SIEMENS ED-FRAME ED2, ED4, ED6, HED4, HED6 8-32 X 3
SQUARE-D
WESTINGHOUSE F-FRAME EHD, FDB, FD, HFD, FDC, HMCP 8-32 X 1-1/2
BREAKER
FRAME
F-FRAME FAL, FHL, FCL 8-32 X 2-7/8
H-FRAME HDL, HGL, HJL 8-32 X 2-5/8
BREAKER STYLE
MOUNTING
HARDWARE
1. CIRCUIT BREAKER INSTALLATION
1. Referring to Figure 2 and the above Table,
select the proper mounting pan location for the
circuit breaker manufacturer.
2. Select the insulating paper for the circuit
breaker manufacturer being installed, discard
the remaining.
3. Align the insulating paper with the mounting
holes located on the mounting pan.
4. Install the circuit breaker onto the mounting pan
using fasteners supplied by the circuit breaker
Figure. 1
manufacturer.
5. Wire the circuit breaker per the governing codes
and electrical standards of your area.
6. Align handle mechanism with the circuit breaker
switch, close the enclosure’s cover and tighten
fasteners per Killark Form No. 1157.
* See Breaker Manufacturer for mounting
hardware.
QTY PAN LOCATION
4 C
4 D
3 A
2 E
4 B
Figure. 2
3940 Dr. Martin Luther King Drive
St. Louis, MO 63113
P/N 00912091 FORM K1158 07/12 ECO-5-029-12
Page 2 of 2
Loading...