Installation Instructions A364
Double Cirque Chandelier 104205 & 19424812 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 30821 A
To Install the Canopy (Figure 1)
Component Parts
A Ground Screw
B Crossbar
C Lock Nut
D Nipple
E Canopy
F Canopy Ring
G Canopy Loop
H Fixture Loop
I Chain
Caution: Be sure power is off at the main breaker box prior to
installation
1. Carefully unpack the fixture from the carton.
2. Screw nipple (D) into canopy loop (G).
3. Spin nut (C) and crossbar (B) onto nipple (D).
4. Using two machine screws (not provided), fasten the
crossbar (B) to the electric box.
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
5. Adjust the length of threaded nipple (D) in crossbar (B) so
that loop collar (F) will hold canopy (E) against the ceiling
with no threads showing on the canopy loop (G) for best
appearance. Make sure the smaller diameter side of
canopy ring is oriented up toward the canopy. When the
correct adjustment is established, tighten lock nut (C)
against crossbar (B) to hold adjustment.
6. Remove the crossbar (B) assembly from electrical box.
7. Attach one end of the chain (I) to the fixture loop (H). Lace
the wires through every other link of the chain (I) to the end.
Slip wires and chain (I) through loop collar (F), and canopy
(E). Fasten the chain (I) to the canopy loop (G).
8. Slip wires through the canopy loop (G) and nipple (D). Make
sure to provide enough slack in the wire to ensure weight of
fixture is supported by the chain (I).
9. Using two machine screws (not provided), reattach the crossbar (B) to the
electric box.
10. Using suitable wire connectors (not provided) connect fixture wires to supply
wires (white to ribbed side of the fixture cord, black to smooth side). Run a pigtail
lead from crossbar ground screw (A) to the junction box and connect all ground
wires (bare copper or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
Installation Instructions A364
Double Cirque Chandelier 104205 & 19424812 Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 30821 A
11. Raise canopy (E) to the ceiling and secure loop collar (F) to canopy loop (G).
12. Install light bulbs (not included).
13. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Loading...