ASSEMBLY & INSTALLATION INSTRUCTIONS
Olympus 4 Light Sconce 201361
B480
49612
1 OF 4
ASSEMBLY & INSTALLATION INSTRUCTIONS
Olympus 4 Light Sconce 201361
Component Parts
A Fixture
B Crossbar
C Ground Screw
D Threaded Stud (2)
E Knob (2)
B480
F Bulb - Not Included
G Socket
H Large Glass Assembly (1)
I Small Glass Assembly (3)
49612
2 OF 4
ASSEMBLY & INSTALLATION INSTRUCTIONS
Olympus 4 Light Sconce 201361
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.
To Install Fixture (Figure 1)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.
1. Carefully unpack the xture (A) from the carton.
2. Thread two studs (D) into the appropriate holes in the crossbar (B) that align with xture (A) and desired orientation.
3. Using two machine screws (not provided) attach crossbar (B) to the electric box using outer oval holes to orient xture. Adjust the studs (D) to proper length to ensure the xture will t snugly against the wall.
Note: A new electric box comes with screws. When replacing a fixture, retain the existing screws for use with the new
fixture.
B480
4. Using suitable wire connectors (not provided) connect fixture wires to supply (white to white and black to black). Attach a pigtail lead to the crossbar ground screw (C). Connect all ground wires (bare copper or green to bare copper or
green).
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON SECURELY, AND NO BARE WIRE IS EXPOSED.
5. Carefully tuck all wires behind xture, push xture rmly against the wall. Secure by threading knobs (E) onto threaded studs (D).
Note: Be sure no wires are pinched between the wall and the fixture. Be sure threaded studs are fully seated in
knobs.
6. See instructions on next page for installing bulbs and glass.
E
A
D
MACHINE
SCREWS
C
B
(Figure 1)
49612
3 OF 4
ASSEMBLY & INSTALLATION INSTRUCTIONS
Olympus 4 Light Sconce 201361
To Install Glass (Figure 2)
1. Locate large and small glass assemblies (H & I)
2. Refer to picture on rst page of instruction for small and
large glass placement.
3. Install bulb (F), not included, into socket (G).
4. Thread glass assembly (H or I) onto socket (G).
5. Repeat for remaining bulbs, glass and sockets.
6. Restore electricity at main breaker.
B480
I
I
G
G
F
I
F
H
If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product. We hope you
enjoy your xture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.
(Figure 2)
49612
4 OF 4
Loading...