ASSEMBLY & INSTALLATION INSTRUCTIONS
Bow 1 Light 201344 and 2 Light 201346 Sconces
B475
201344
(Shown in lnstructions)
201346
48384
1 OF 4
ASSEMBLY & INSTALLATION INSTRUCTIONS
Bow 1 Light 201344 and 2 Light 201346 Sconces
Component Parts
A Fixture
B Mounting Bracket
C Ground Screw
D Cupped Washer
E #8 Screws (3)
F Socket
B475
G Bulb (not included)
H Glass
I Retaining Ring
J Retaining Ring Tool
48384
2 OF 4
ASSEMBLY & INSTALLATION INSTRUCTIONS
B475
Bow 1 Light 201344 and 2 Light 201346 Sconces
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.
To Install Fixture (Figure 1)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.
1. Carefully unpack the xture (A) from the carton. Mounting bracket (B) is shipped installed in xture (A). Remove #8
screws (E) to separate. Retain screws for later use.
2. Using two machine screws (not provided) attach mounting bracket (B) to the electric box using oval holes to orient
xture.
Note: A new electric box comes with screws. When replacing a fixture, retain the existing screws for use with the new
fixture.
3. Hold xture (A) close to to wall. Using suitable wire connectors (not provided) connect fixture wires to supply (white to
white and black to black). Attach a pigtail lead to bracket (B) using ground screw (C) and cupped washer (D). Connect all ground wires (bare copper or green to bare copper or green).
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON SECURELY, AND NO BARE WIRE IS EXPOSED.
4. Carefully tuck all wires inside xture (A), push xture rmly against wall.
5. Align holes in xture (A) with holes in bracket (B) and secure with (3) #8 screws (E). For ease of install, start all
screws before tightening completely.
Note: Be sure no wires are pinched between the wall and the fixture.
6. See instructions on next page to complete installation.
C D
(Figure 1)
A
MACHINE
SCREWS
BE
48384
3 OF 4
ASSEMBLY & INSTALLATION INSTRUCTIONS
Bow 1 Light 201344 and 2 Light 201346 Sconces
To Install Glass (Figure 2)
1. Install bulb (G), not included, into socket (F).
2. Carefully unpack glass (H) and slide over bulb until it
rests on xture (A).
3. Place retaining ring (I) into retaining ring tool (J). Thread
retaining ring (I) onto socket to secure glass (H).
Note: Be sure not to overtighten as this could break
glass.
4. Repeat for remaining sockets & glass if installing 2 light
version.
5. Restore electricity at the main breaker
B475
J
I
H
G
F
A
(Figure 2)
If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product. We hope you enjoy your xture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.
48384
4 OF 4
Loading...