ASSEMBLY & INSTALLATION INSTRUCTIONS
Brooklyn 4lt Single Shade Semi Flush 121375
A752
48372
1 OF 4
ASSEMBLY & INSTALLATION INSTRUCTIONS
Brooklyn 4lt Single Shade Semi Flush 121375
Component Parts
A Fixture
B Mounting Bracket
C Ground Screw
D Cupped Washer
E #8 Screws (4)
F Collar (4)
A752
G Socket (4)
H Accent Shade (4)
I Bulb - Not Included (4)
J Glass (4)
48372
2 OF 4
ASSEMBLY & INSTALLATION INSTRUCTIONS
Brooklyn 4lt Single Shade Semi Flush 121375
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.
To Install Fixture (Figure 1)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.
1. Carefully unpack the xture (A) from the carton.
2. Mounting bracket (B) is shipped installed in xture
(A). Remove #8 screws (E) to separate. Retain
screws for later use.
A752
3. Using two machine screws (not provided) attach
crossbar (B) to the electric box using oval holes to
orient xture.
Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture.
4. Hold xture (A) close to ceiling. Using suitable
wire connectors (not provided) connect fixture
wires to supply (white to white and black to black).
Attach a pigtail lead to bracket (B) using ground
screw (C) and cupped washer (D) found in kit bag.
Connect all ground wires (bare copper or green to
bare copper or green).
CAUTION: MAKE SURE WIRE CONNECTORS
ARE TWISTED ON SECURELY, AND NO BARE
WIRE IS EXPOSED.
5. Carefully tuck all wires inside xture (A), push
xture rmly against the ceiling.
6. Align holes in xture (A) with holes in bracket (B)
and secure with (4) #8 screws (E). For ease of install, start all screws before tightening completely.
Note: Be sure no wires are pinched between the
ceiling and the fixture.
B
MACHINE
SCREWS
C
D
E
A
7. See instructions on next page to complete installation.
(Figure 1)
48372
3 OF 4
ASSEMBLY & INSTALLATION INSTRUCTIONS
Brooklyn 4lt Single Shade Semi Flush 121375
To Install Accent Shade and Glass (Figure 2)
1. Install bulb (I), not included, into socket (G).
2. Carefully unpack glass (J).
3. Slide accent shade (H) over bulb (I) and socket (F) and up against nozzle. Rotate to desired location.
4. Thread glass (J) over socket (G) and onto collar (F) to secure accent shade (H) against nozzle.
5. Restore electricity at the main breaker
NOZZLE
F
G
A752
(Figure 2)
I
H
J
If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product. We hope you enjoy your xture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.
48372
4 OF 4
Loading...