Page 1
Installation Instructions F15
p
For Rook Toilet Paper Holder 84-4005
CAUTION: FAILURE TO INSTALL THIS PRODUCT PROPERLY MAY RESULT IN PERSONAL INJURY
OR PROPERTY DAMAGE. We recommend installation by a qualified individual trained in the building trade.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and o
To Install Component Parts
A Mounting Arm (2)
B Set Screw (2)
C Wall Mount Plate (2)
D Screws (4)
1. Remove wall mount plate (C) from the mounting arm (A) by
loosening set screw (B) and sliding wall mount plate (C) from
mounting arm (A). Do this for both arms (Figure 1).
2. Hold first wall mount plate (C) in location it is to be mounted.
With a pencil, mark the location of the mounting holes in the
wall mount plate (C) on the wall behind.
3. Measure 5 1/4" from the marked holes for the location of the
second wall mount plate (C).
4. Put the wall mount plate down and drill 1/4" holes in
the locations marked on the wall if wall anchors (E)
are to be used.
support the drilled hole is not needed.
using anchors, place the tapered end of the anchors
(E) into the holes and gently tap them flush to the
wall using a light weight hammer.
5. Install screws (D) through wall mount plates (C) and
into each anchor (E).
screws (D) can be installed directly to the wall.
6. Tighten set screw (B) in both arms.
7. Remove tape from end of removable bar (F) and
discard.
eration of the product and the hazards involved.*
E Wall Anchors (4)
F Removable Bar
G Fixed Bar
H Magnet
(Figure 1)
If directly attaching to a solid
For holes
If anchors are not needed the
(Figure 2)
8. Slip removable bar (F) through mounting arm (A) with
magnet pointing towards second mounting arm (A) with
fixed bar (G).
9. Once past first arm slip toilet paper roll onto removable
bar (F) and slip bar into second mounting arm until
magnet (H) is touching fixed bar (G).
If you need further assistance, or find that you are missing any
parts, please contact the dealer from which you purchased this
product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage
caused by improper installation or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
(Figure 3)
24320
Loading...