Mirror Installation Instructions F08
CAUTION: FAILURE TO INSTALL THIS PRODUCT PROPERLY MAY RESULT IN PERSONAL
INJURY OR PROPERTY DAMAGE. We recommend installation by a qualified individual trained in the
building trade.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Component Parts
A Anchor
B Z Strip
C Screw
D Hanger strip
E Felt pads (4)
To Install
Caution: Mirror is heavy. Make sure the mounting surface is in good repair and capable of supporting the weight of
the mirror. If in doubt, consult a qualified builder. Attaching mirror directly to a framing member is recommended. If
attaching directly to a framing member, omit anchor (A) from the installation.
1. Place Z strip (B) against wall at the desired location and mark locations of anchors. Be sure Z strip is level when
marking.
2. Install anchors (A), if applicable, by threading directly into the drywall using a number 2 Phillips screwdriver.
3. Install screws (C) through Z strip (B) and into each anchor or directly into a framing member.
4. Mount the 4 felt pads (E) on the corners facing the wall.
5. Hang mirror on Z strip by placing the hanger strip (D) between the lip of the Z strip and the wall.
* Hubbardton Forge will not be liable for injury or damage caused by improper installation or use of this product.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
16531
Loading...