Page 1
Mirror Installation Instructions F07
CAUTION: FAILURE TO INSTALL THIS PRODUCT PROPERLY MAY RESULT IN PERSONAL
INJURY OR PROPERTY DAMAGE. We recommend installation by a qualified individual trained in the
building trade.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Component Parts
A Anchor
B Screw
C Saw Tooth Hanger strip
To Install
Caution: Mirror is heavy. Make sure the mounting surface is in good repair and capable of supporting the weight of
the mirror. If in doubt, consult a qualified builder. Attaching mirror directly to a framing member is recommended. If
attaching directly to a framing member, omit anchor (A) from the installation.
1. Install anchor (A), if applicable, by threading it directly into the drywall using a number 2 Phillips screwdriver.
2. Install screw (B) into anchor, or directly into framing member, leaving approximately 1/8" of space between the
head of the screw and the wall surface.
3. Hang and level mirror from screw by placing the saw tooth hanger strip (C) onto the screw.
* Hubbardton Forge will not be liable for injury or damage caused by improper installation or use of this product.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
16530
Loading...