Hubbardton Forge 366520 User Manual

Installation Instructions A277

For Ceiling Fixture 36-6515 & 36-6520 Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

To Install the Canopy (Figure 1)

Component Parts

A Ground Screw
B Crossbar
C Lock Nut
D Nipple
E Canopy

Caution: Be sure power is off at the main breaker box prior to
installation

1. Carefully unpack the fixture from the carton.

2. Using two machine screws (not provided), fasten the

crossbar (B) to the electric box.

Note: A new electric box comes with screws. When
replacing a fixture, retain the existing screws for use with the
new fixture.

3. Thread the nipple (D) into the crossbar (B) and secure with

lock nut (C); slide canopy (E) over nipple (D), and attach the
canopy loop (F) to the nipple (D). Adjust the nipple to
proper length to ensure a snug canopy fit before proceeding.

4. Attach one end of the chain (I) to the fixture loop (H). Lace

the wire through every other link of the chain to the end. Slip
wires and chain through the collars and canopy (G, F & E).
Fasten the chain to the canopy loop (F) then slip wires
through the loop and nipple, into the electric box. Make sure
to provide enough slack in the wire to ensure weight of
fixture is supported by the chain.

5. Using suitable wire connectors (not provided) connect

fixture wires to supply wires (white to ribbed side of the
fixture cord, black to smooth side). Run a pigtail lead from
crossbar ground screw (A) to the junction box and connect
all ground wires (bare copper or green to bare copper or
green).

Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.

6. Raise canopy (E) to the ceiling and secure loop collar (G) to

canopy loop (F).

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

F Canopy Loop
G Loop Collar
H Fixture Loop
I Chain

(Figure 1)

(continued)

26601

Installation Instructions A277

For Ceiling Fixture 36-6515 & 36-6520 Page 2 of 2

To Install Glass

Component Parts

J Retaining Ring
K Glass
L Socket
M Retaining Ring Tool
N Bulb

(Figure 2)

1. Remove retaining ring (J) from socket (L). Retaining Ring is

shipped installed.

2. Place glass (K) over socket (L).

3. Replace retaining ring (J) and tighten with retaining ring tool

provided (M) until snug against glass (K). Do not over-tighten.

4. Install bulb (N). (Included). Be careful not to touch bulb with

bare hands; oil from the hands will dramatically reduce bulb
life.

5. Restore electricity at the main breaker.

(Figure 2)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

26601