Hubbardton Forge 366005 User Manual

Installation Instructions A269

For Tourou Ceiling Fixture 36-6005 Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

To Install the Canopy (Figure 1)

Component Parts

A Ground Screw
B Crossbar
C Lock Nut
D Nipple
E Canopy

Caution: Be sure power is off at the main breaker box prior to installation

1. Carefully unpack the fixture from the carton.

2. Using two machine screws (not provided), fasten the crossbar (B) to the

electric box.

Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.

3. Thread the nipple (D) into the crossbar (B) and secure with lock nut (C);

slide canopy (E) over nipple (D), and attach the canopy loop (F) to the
nipple (D). Adjust the nipple to proper length to ensure a snug canopy fit
before proceeding.

4. Attach one end of the chain (I) to the fixture loop (H). Lace the wire

through every other link of the chain to the end. Slip wires and chain
through the collars and canopy (G, F & E). Fasten the chain to the canopy
loop (F) then slip wires through the loop and nipple, into the electric box.
Make sure to provide enough slack in the wire to ensure weight of fixture
is supported by the chain.

5. Using suitable wire connectors (not provided) connect fixture wires to

supply wires (white to ribbed side of the fixture s cord, black to smooth
side). Run a pigtail lead from crossbar ground screw (A) to the junction
box and connect all ground wires (bare copper or green to bare copper or
green).

Caution: Make sure wire connectors are twisted on securely, and no
bare wire is exposed.

6. Raise canopy (E) to the ceiling and secure loop collar (G) to canopy

loop (F).

F Canopy Loop
G Loop Collar
H Fixture Loop
I Chain

(Figure 1)

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

(continued)

24850

Installation Instructions A269

For Tourou Ceiling Fixture 36-6005 Page 2 of 2

To Install Glass

Component Parts

J Retaining Ring
K Glass
L Socket
M White Washer

(Figure 2)

1. Remove retaining ring (J) from socket (L). Retaining Ring is shipped installed.

2. Place glass (K) over socket (L).

3. Slip white washer (M) onto socket (L) until it rests on top of glass (K).

4. Replace retaining ring (J) and tighten until snug against white washer (M) to

secure glass. Do not over-tighten.

5. Install light bulb. Not included

6. Restore electricity at the main breaker.

(Figure 2)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

24850