Hubbardton Forge 365710 User Manual

Installation Instructions A319

CAUTION: FAILURE TO INSTALL THI S FIXTURE PROPERLY MAY RESULT I N SERIO US PERSO NAL

(Figure 1)

Modern Prairie Chain Hung 36-5705 & 36-5710 Page 1 of 2

INJURY OR DEATH AND PROPERTY DAMAGE. We rec o mm e nd installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

To Install the Canopy (Figure 1)

Component Parts

A Ground Screw
B Crossbar
C Lock Nut
D Nipple
E Canopy

Caution: Be sure power is off at the main breaker box prior to installation

1. Carefully unpack the fixture from the carton.

2. Using two machine screws (not provided), fasten the crossbar (B) to the

electric box.

Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.

3. Thread the nipple (D) into the crossbar (B) and secure with lock nut (C).

Slide canopy (E) over nipple (D), and attach the canopy loop (F) to the
nipple (D). Thread loop collar (G) onto canopy loop (F). Adjust the
nipple to proper length to ensure a snug canopy fit before proceeding.

4. Remove loop collar (G) and canopy (E) before proceeding with

installation.

5. Attach one end of the chain (I) to the fixture loop (H). Lace the wire

through every other link of the chain to the end. Slip wires and chain
through the collar and canopy (G & E). Fasten the chain to the canopy
loop (F) then slip wires through the loop and nipple, into the electric bo x.
Make sure to provide enough slack in the wire to ensure weight of fixture
is supported by the chain.

6. Using suitable wire connectors (not provided) connect fixture wires to

supply wires (white to ribbed side of the fixture cord, black to smooth
side). Run a pigtail lead from crossbar ground screw (A) to the junction
box and connect all ground wires (bare copper or green to bare copper or
green).

Caution: Make sure wire connectors are twisted on securely, and no
bare wire is exposed

7. Raise canopy (E) to the ceiling and secure loop collar (G) to canopy

loop (F).

Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735

F Cano p y Loop
G Loop Collar
H Fixture Loop
I Chain

27926

(continued)

Installation Instructions A319

(Figure 2)

(Figure 3)

Modern Prairie Chain Hung 36-5705 & 36-5710 Page 2 of 2

To Install Glass (Figures 2 & 3)

Component Parts

J Fixture
K Decorative Assembly
L Glass
M #8 Flat Head Screws

1. Remove decorative assembly (K) by removing (4) #8 flat head screws (M). Decorative assembly ships installed.

2. Install bulb (not included).

3. Slip glass (L) into decorative assembly (K).

4. Attach decorative assembly (K) with glass (L) to fixture assembly (J)

using (4) #8 flat head screws (M).

5. Restore electricity at main breaker.

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735

27926