Hubbardton Forge 364903 User Manual

Installation Instructions A244

For Twilight Semi-Flush 36-4903 & 36-4903F Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.

After installation extra hardware and accessories are possible; our kits are used on multiple products and options.

To Install Fixture (Figure 1)

Component Parts

A Ground Screw
B Cross Bar
C Threaded Stud (2)
D Canopy
E Barrel Knobs (2)

Caution: Be sure power is off at the main breaker
box prior to installation.

1. Carefully unpack the fixture from the carton.

2. Thread studs (C) through appropriate holes in

cross bar (B) to match hole centers in canopy
(D). Move ground screw (A) to another
available threaded hole if necessary.

3. Using two machine screws (not provided)

fasten cross bar (B) to the electric box using
outer oval holes to orient fixture to desired
hanging position.

Note: A new electric box comes with screws.
When replacing an existing fixture, retain the
screws for use with the new fixture.

4. Using suitable wire connectors (not

provided); connect fixture wires to supply
wires (white to white and black to black).
Connect all ground wires to green ground
screw (A).

Caution: Make sure wire connectors are
twisted on securely, and no bare wire is
exposed.

5. Slide fixture canopy (D) over threaded studs

and push firmly to ceiling, making sure that
no wires are pinched between fixture canopy and
ceiling. Fasten with barrel knobs (E). Be sure
studs (C) are fully seated in barrel knobs (E).

(Figure 1)

(continued)

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

24577

Installation Instructions A244

For Twilight Semi-Flush 36-4903 & 36-4903F Page 2 of 2

To Install Bulb & Bottom Assembly (Figures 2 & 3)

Component Parts

F Socket
G Bottom Assembly
H Threaded Bosses (2)
I Screws (2)
J Washer

1. Unthread screws (I) that are shipped installed in

threaded bosses on fixture next to socket (F).
Loosen screws until there are only a couple
threads engaged with the threaded bosses.

2. Raise bottom assembly (G) over socket (F)

aligning holes in washer (J) so the washer keyed
ring goes over screws (I).

3. Turn washer (J) clockwise until it stops. Tighten

two screws (I) until snug against washer (J)
(Figure 3).

4. Install light bulb. “F” version bulb in included.

5. Restore electricity at main breaker.

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

(Figure 2)

(Figure 3)

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

24577