Hubbardton Forge 307530 User Manual
Installation Instructions B139
For Large Ellipse Outdoor Wall sconce 30-7530 & 307530F Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
For fixtures requiring assembly, please refer to assembly instructions before installation.
To Install Fixture
Component Parts
A Cross Bar
B Threaded Studs (2)
C Fixture
D Barrel Knobs (2)
E Caulking Lip
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the
carton.
2. Using two machine screws (not
provided) attach cross bar (A) to the
electric box using inside oval holes to
orient fixture.
box comes with screws. When
replacing a fixture, retain the screws
for use with the new fixture.
Note: A new electric
3. Start threaded studs (B) into
appropriate holes in crossbar (A).
4. Using suitable wire connectors (not
provided), connect the fixture wires to
the supply wires, (white to white,
black to black, bare copper or green to
bare copper or green). If the fixture is wired
with twin lead lamp cord, connect the ribbed side to
white, and the smooth side to black.
Caution: Make sure wire connectors are twisted on
securely and no bare wires are exposed.
5. Apply a generous bead of a suitable caulking material to
caulking lip (E) on the fixture.
6. Carefully tuck all wires behind the fixture. Place fixture
(C) over threaded studs (B) and tighten firmly to
mounting surface using barrel knobs (D).
(Figure 1)
(Figure 2)
(continued)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
21181
Installation Instructions B139
For Large Ellipse Outdoor Wall sconce 30-7530 & 307530F Page 2 of 2
To Install Glass
Component Parts
C Fixture
F Screws (3)
G Glass
H Washer
I Retaining Ring
J Socket
(Figures 3 & 4)
1. Unthread screws (F) that are shipped installed in threaded tubes on
underside of fixture next to socket (J). Loosen screws until there are
only a couple threads engaged with the threaded tubes.
2. Raise glass (G) and washer (H) over socket (J) aligning holes in washer
(H) so the washer keyed ring goes over screws (F).
3. Turn washer (H) counter clockwise until it stops. Tighten three screws
(F) until snug against the inside of glass (G). Be careful not to over
tighten.
4. Thread retaining ring (I) on to socket (J) until snug against washer (H).
Note: Retaining ring alone is not enough to hold glass permanently.
5. Install light bulb. (For fluorescent version bulb is supplied.)
6. Restore electricity at the main breaker.
(Figure 3)
(Figure 4)
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
21181
Loading...