Page 1
Installation Instructions B141
For Ellipse Outdoor Wall Sconce 30-7521, 30-7521F, 30-7525 & 30-7525F Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
To Install Fixture
Component Parts
A Cross Bar
B Threaded Studs (2)
C Fixture
D Barrel Knobs (2)
E Caulking Lip
Caution: Be sure power is off at the main breaker box prior
to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided) attach cross
bar (A) to the electric box using inside oval holes to
orient fixture.
Note: A new electric box comes with screws. When
replacing a fixture, retain the screws for use with the
new fixture.
Start threaded studs (B) into appropriate holes in crossbar (A).
3.
Using suitable wire connectors (not provided), connect the
4.
fixture wires to the supply wires, (white to white, black to
black, bare copper or green to bare copper or green). If the
fixture is wired with twin lead lamp cord, connect the ribbed
side to white, and the smooth side to black.
Caution: Make sure wire connectors are twisted on securely
and no bare wires are exposed.
5. Apply a generous bead of a suitable caulking material to
caulking lip (E) on the fixture.
6. Carefully tuck all wires behind the fixture. Place fixture (C)
over threaded studs (B) and tighten firmly to mounting surface
using barrel knobs (D).
(Figures 1 & 2)
(Figure 1)
(Figure 2)
(continued)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
21192
Page 2
Installation Instructions B141
For Ellipse Outdoor Wall Sconce 30-7521, 30-7521F, 30-7525 & 30-7525F Page 2 of 2
To Install Glass
Component Parts
C Fixture
F Glass
G Retaining Ring
H Socket
I Socket Tool (provided only with 30-7521 & 30-7521F)
(Figure 3)
1. Remove retaining ring (G) from socket (H).
2. Slip glass (F) over socket (H).
3. Thread retaining ring (G) onto socket using socket tool provided (I) until it rests
on inside of glass (F).
Note: Socket tool is only used for products 30-7521 & 30-7521F. Do not over
tighten.
4. Install light bulb and restore electricity at main breaker. Fluorescent version
bulb is provided with fixture.
(Figure 3)
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
21192
Loading...