Installation Instructions B215
For Tourou Outdoor Sconce 30-6006, 30-6006F, 30-6007, 30-6007F, 30-6008 & 30-6008F Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
For fixtures requiring assembly, please refer to assembly instructions before installation.
To Install Fixture
Component Parts
A Cross Bar
B Threaded Studs (2)
C Fixture
D Knurled Balls (2)
E Caulking Lip
Caution: Be sure power is off at the main breaker box prior to
installation.
(Figure 1 & 2)
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided) attach cross bar (A) to
the electric box using inside oval holes to orient fixture.
new electric box comes with screws. When replacing a fixture,
retain the screws for use with the new fixture.
Note: A
3. Start threaded studs (B) into appropriate holes in crossbar (A).
4. Using suitable wire connectors (not provided), connect the
fixture wires to the supply wires, (white to white, black to black,
bare copper or green to bare copper or green). If the fixture is
wired with twin lead lamp cord, connect the ribbed side to white,
and the smooth side to black.
Caution: Make sure wire connectors are twisted on securely
and no bare wires are exposed.
5. Apply a generous bead of a suitable caulking material to caulking
lip (E) on the fixture.
6. Carefully tuck all wires behind the fixture. Place fixture (C) over
threaded studs (B) and tighten firmly to mounting surface using
knurled balls (D).
(Figure 1)
(Figure 2)
(continued)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
24851 Rev B
Installation Instructions B215
For Tourou Outdoor Sconce 30-6006, 30-6006F, 30-6007, 30-6007F, 30-6008 & 30-6008F Page 2 of 2
To Install Glass
Component Parts
F Retaining Ring
G Glass
H Socket
I White Washer (Not needed on Products 30-6006 & 30-6006F)
(Figure 3)
1. Remove retaining ring (F) from socket (H). Retaining Ring is shipped
installed.
2. Place glass (G) over socket (H).
3. Slip white washer (I) onto socket (H) until it rests on top of glass (G).
(Note: Washer is not needed on products 30-6006 & 30-6006F).
4. Replace retaining ring (F) and tighten until snug against white washer (I)
or top of glass depending on product being installed to secure glass. Do
not over-tighten.
5. Install light bulb. (âFâ version bulb is included)
6. Restore electricity at the main breaker.
(Figure 3)
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
24851 Rev B
Loading...