Installation Instructions B109
g
For Direct Wire Fluorescent Wall-Mounted Wet-Location Fixtures Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum watta
For fixtures requiring assembly, please refer to assembly instructions before installation.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Install the Fixture (Figure 1)
Component Parts
A Fixture
B Knurled Balls (2)
C 8-32 Studs (2)
D Cross Bar
E Caulking Lip
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided) attach cross bar (D) to
the electric box using outer oval holes to orient fixture.
Note: A new electric box comes with screws. When replacing a
fixture, retain the screws for use with the new fixture.
3. Thread the two studs (C) into the appropriate holes in the crossbar
(D). Adjust the studs to proper length to ensure the fixture will fit
snugly to the wall.
4. Using suitable wire connectors (not provided), connect the fixture
wires to the supply wires, (white to white, black to black, bare
copper or green to bare copper or green).
wire connectors are twisted on securely and no bare wires are
exposed.
5. Apply a generous bead of a suitable caulking material (not
supplied) to caulking lip (E) on the fixture.
6. Carefully tuck all wires behind the fixture, place fixture firmly
against the wall and fasten with knurled balls (B). To ensure a
water tight seal, apply a thin bead of caulking around entire
perimeter of the fixture (E).
7. Install light bulb (not provided) and glass. (See to install glass
section)
8. Restore electricity at the main breaker.
e noted on fixture. Use only recommended bulbs with fixture.
Caution: Make sure
(Figure 1)
(continued)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
19767 Rev A
Installation Instructions B109
For Direct Wire Fluorescent Wall-Mounted Wet-Location Fixtures Page 2 of 2
To Install Glass
Component Parts
F Socket
G Glass
H Retaining Ring
I Bulb (provided)
1. Unthread retaining ring (H) from socket (F) and save for later use.
2. Place glass (G) over socket (F).
3. Thread retaining ring (H) on to socket (F) until snug against top of glass (G).
Be careful not to over tighten.
4. Install light bulb (I).
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 2)
(Figure 2)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
19767 Rev A
Loading...