Hubbardton Forge 304901 User Manual
Installation Instructions B207
For Twilight Outdoor Sconce 30-4901 Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
After installation extra hardware and accessories are possible; our kits are used on multiple products and options.
To Install Fixture (Figures 1 & 2)
Component Parts
A Cross Bar
B Threaded Studs (2)
C Fixture
D Barrel Knobs (2)
E Caulking Lip
Caution: Be sure power is off at the main breaker box prior
to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided) attach cross
bar (A) to the electric box using inside oval holes to
orient fixture.
screws. When replacing a fixture, retain the screws for
use with the new fixture.
Note: A new electric box comes with
3. Start threaded studs (B) into appropriate holes in
crossbar (A).
4. Using suitable wire connectors (not provided), connect the
fixture wires to the supply wires, (white to white, black to
black, bare copper or green to bare copper or green). If the
fixture is wired with twin lead lamp cord, connect the
ribbed side to white, and the smooth side to black.
Caution: Make sure wire connectors are twisted on
securely and no bare wires are exposed.
5. Apply a generous bead of a suitable caulking material to
caulking lip (E) on the fixture.
6. Carefully tuck all wires behind the fixture. Place fixture
(C) over threaded studs (B) and tighten firmly to mounting
surface using barrel knobs (D).
(Figure 1)
(Figure 2)
(continued)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
24452
Installation Instructions B207
For Twilight Outdoor Sconce 30-4901 Page 2 of 2
To Install Glass (Figures 3 & 4)
Component Parts
C Fixture
F Top Cover
G Glass
H Bulb (Included)
1. Install light bulb (H). Be careful not to touch bulb with bare
hands; oil from the hands will dramatically reduce bulb life.
2. Slide glass (G) into fixture (C) aligning the slot in the glass
with the area of the fixture (C) noted in Figure 3 and shown in
Figure 4. Slide glass into fixture until it rests on the lip inside
the fixture. It may be necessary to push glass towards the front
of the fixture to prevent the glass from rocking or not sitting
straight.
3. Install top cover (F). If light in the up direction is preferred do
not install top cover.
4. Restore electricity at the main breaker.
(Figure 3)
(Figure 4)
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
24452
Loading...