Hubbardton Forge 277670 User Manual

Shade Installation Instructions C49

Figure 1

Figure 2

Cavaletti Table Lamp 277670 & 277670C Page 1 of 1

To Install Glass Diffuser & Shade (Figure 1)

Component Parts

A Finial
B Washer
C Diffuser
D Shade
E Socket
F Threaded Stud

1. Carefully unpack the lamp from the carton.

2. Remove finial (A) and washer (B) from threaded stud (F) and

save for later use. Finial and washer are shipped installed.

3. Install bulbs. Bulbs are included in the “C” version.

4. Slip shade (D), diffuser (C), and washer (B) onto threaded stud

(F) on top of socket (E). See Figure 2 for washer orientation.

5. Thread finial (A) onto threaded stud (F) on socket (E) a nd tighten

until snug. Be careful not to over tighten.

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

*

Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735

28110