Page 1
Shade Installation Instructions C47
Figure 1
Figure 2
Figure 3
Rene Table Lamps 27-3080, 27-3080C & Lino Table Lamps 27-3085, 27-3085C
To Install Glass Diffuser (Figures 1-3)
Component Parts
A Turn Knob F Finial
B Harp Holder G Washer
C Socket H Diffuser
D Locks (2) I Shade
E Harp
1. Carefully unpack the lamp from the carton.
2. Install turn k nob (A) onto socket (Figure 1).
3. Remove finial (F) from harp (E) and save for later use.
Finial is shippe d i nstal led on harp.
4. Squeeze harp (E) together while holding the locks (D) up
towards the top of the harp (E) and slip into harp holder (B).
5. Allow locks (D) to slip down harp (E) and onto harp holder (B) to
secure harp in place.
6. Install bulb. “C” version bulb is included.
7. Slip shade (I), diffuser (H) and washer (G) onto threaded stud on
top of harp (E). See Figure 3 for washer orientation.
8. Thread finial (F) onto threaded stud on harp (E) and tighten until
snug. Be careful not to over tighten.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
*
Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting a nd A c cessories
154 Route 30 South, Castleton, Vermont 05735
28098
Loading...