Page 1
Shade Installation Instructions C45
Brindille Floor Lamp 237660 & 237660C
To Install Glass Diffuser
Component Parts
A Finial
B Washer
C Diffuser
D Shade
E Harp
F Socket Knob
G Harp Holder
H Socket
I Locks (2)
(Figures 1 - 3)
1. Carefully unpack the lamp from the carton.
2. Install socket knob (F) onto socket (Figure 1).
3. Remove finial (A) from harp (E) and save for later use. Finial
is shipped installed on harp.
4. Squeeze harp (E) together while holding the locks (I) up
towards the top of the harp (E) and slip into harp holder (G)
(Figure 1).
5. Allow locks (I) to slip down harp (E) and onto harp holder
(G) to secure harp in place.
6. Install bulb (included on C version).
7. Slip shade (D), diffuser (C) and washer (B) onto threaded
stud on top of harp (E). See Figure 3 for washer orientation.
8. Thread finial (A) onto threaded stud on harp (E) and tighten
until snug. Be careful not to over tighten.
Figure 1
Figure 3
Figure 2
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
*
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
27230
Loading...