Hubbardton Forge 234901 User Manual

Shade Installation Instructions C32

2

For Rook Table & Floor Lamp 23-4901, 23-4901C, 26-4901 & 26-4901C, Page 1 of 2

To Install Glass

Component Parts

A Socket
B Glass
C Retaining Ring (2)
D Retaining Ring Tool

(Figure 1)

1. Carefully unpack the lamp from the carton.

2. Remove retaining rings (C) from socket (A). Retaining Rings are shipped

installed.

3. Place glass (B) over socket (A).

4. Using provided retaining ring tool (D) thread the first retaining ring (C) onto

socket (A) until it reaches the bottom of the glass (B).

5. Using provided retaining ring tool (D) thread the second retaining ring (C)

and tighten until it is snug against the first retaining ring.

6. Install bulb. “C” version bulb is included.

To Install Diffuser & Shade

Component Parts

E Finial
F Washer

G Diffuser
H Shade
I Thumb Screw
J Diffuser Bracket
K Fixture Bracket
L Threaded Stud

(Figure 2)

1. Remove thumb screw (I) from fixture bracket (K). Save for later

use.

2. Attach diffuser bracket (J) to fixture bracket (K) using thumb screw

(I). Align diffuser bracket (J) to be centered on the fixture and
tighten thumb screw (I).

3. Slip shade (H), diffuser (G) and washer (F) onto threaded stud (L).

4. Thread finial (E) onto threaded stud (L) and tighten until snug. Be

careful not to over tighten.

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

Figure 1

Figure

(continued)

24623

Shade Installation Instructions C32

For Rook Table & Floor Lamp 23-4901, 23-4901C, 26-4901 & 26-4901C, Page 2 of 2

To Replace Bulb

Component Parts

E Finial
F Washer
G Diffuser
H Shade
I Thumb Screw
J Diffuser Bracket

1. Remove finial (E) followed by washer (F) and diffuser (G).

2. Loosen thumb screw (I).

3. Slide diffuser bracket (J) to access the bulb (Figure 4).

4. Replace bulb.

5. Slide diffuser bracket (J) back to original location and tighten

thumb screw (I).

6. Reinstall diffuser (G), washer (F) and finial (E).

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

*

Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

(Figure 3)

Figure 3

Figure 4

Figure 5

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

24623