Hubbardton Forge 217523 User Manual
Installation Instructions B193
For Aperture Vertical Sconce 21-7523F Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products and
options.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Fixture
B Screw Cap
C Nipple
D Crossbar
E 8-32 X 3/4" Screws (2)
Caution: Be sure power is off at the main breaker box
prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (E) attach cross bar
(D) to the electric box.
3. Thread the nipple (C) into the crossbar (D). Place
fixture (A) on wall to make sure nipple protrudes
thru front of fixture (A). Adjust nipple distance
as needed.
4. Using suitable wire connectors (not provided),
connect the fixture wires to the supply wires,
(white to white, black to black, bare copper or
green to bare copper or green). If the fixture is
wired with twin lead lamp cord, connect the
ribbed side to white, and the smooth side to black.
Caution: Make sure wire connectors are twisted
on securely and no bare wires are exposed.
5. Carefully tuck all wires behind the fixture, place
fixture firmly against the wall and fasten screw
cap (B).
6. See instructions following to complete installation.
Figure 1
(continued)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
22882
Installation Instructions B193
For Aperture Vertical Sconce 21-7523F Page 2 of 2
To Install Glass (Figure 2)
Component Parts
F Front Assembly
G Glass (2)
H Glass Spring
1. Slide glass (G) with dull side towards bulb into slots in front assembly
(F) until the holes in the glass (G) engage with the glass spring (H).
To Install Front Assembly
Component Parts
A Fixture
F Front Assembly
I Cap Screw (2)
J Set Screw
1. Install light bulb (Not Included).
2. Slip front assembly (F) onto two cap screws (I) by aligning top slot and
keyed slot with the cap screws (I) installed in fixture (A). When front is
as far back as it will go slide fixture down to secure.
3. Tighten set screw (J) until snug against cap screw (I) (Figure 4).
(Figures 3 & 4)
Figure 2
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
(Figure 3)
(Figure 4)
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
22882
Loading...