Hubbardton Forge 217510 User Manual
Installation Instructions B176
g
For Aperture Sconce 21-7510 Page 1 of 3
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: This fixture is designed to be mounted on a standard wall surface and
may not be suitable for all applications. If installing in a non-wood frame application,
we recommend consulting a qualified builder or electrician.
Please Note: After installation extra hardware and accessories are possible; our kits
are used on multiple products and options.
To Mount Fixture to Wall (Figures 1 & 2)
Component Parts
A Fixture Back
B Fixture Front
C Locking Screw
D Cap Screw (2)
E Screw Cap
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Remove fixture front (B) from fixture back (A) by loosening locking
screw (C).
assemblies are shipped together.
Note: It is not necessary to remove locking screw (C). Two
over cap screws (D). Set aside for later use.
3. Using two machine screws (not provided) attach cross bar (H) to the electric
Note: A new electric box comes with screws. When replacing a fixture,
box.
retain the screws for use with the new fixture.
4. Thread the nipple (F) into the crossbar and secure
with lock nut (G). Adjust the nipple to proper length
to ensure the fixture will fit snugly to the wall.
5. Using suitable wire connectors (not provided),
connect the fixture wires to the supply wires, (white
to white, black to black, bare copper or green to bare
copper or green). If the fixture is wired with twin lead
lamp cord, connect the ribbed side to white, and the
smooth side to black.
Caution: Make sure wire connectors are twisted on
securely and no bare wires are exposed.
6. Carefully tuck all wires behind the fixture, place
fixture firmly against the wall and fasten screw
cap (E).
7. See instructions following to complete install.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
F Nipple
G Lock Nut
H Crossbar
I Ground Screw
Slide fixture front (B) up to allow it to slip
ure 1
Fi
Figure 2
(continued)
22736 Rev A
Installation Instructions B176
For Aperture Sconce 21-7510 Page 2 of 3
To Install Front (Figures 3 & 4)
Component Parts
A Fixture Back
B Fixture Front
C Locking Screw
D Cap Screw (2)
J Bulb (Included)
1. Install light bulb (J). Be careful not to touch bulb with bare hands; oil from your hands will reduce bulb life.
Note: When replacing the bulb it will be necessary to remove the glass on the right hand side to allow the front
assembly to be removed.
2. Slip fixture front (B) onto two cap screws (D) by aligning keyed slots with the cap screws (D) installed in fixture
back (A). When front assembly is as far back as it will go slide fixture to the right to secure.
3. Tighten locking screw (C) until snug. (Figure 4)
(Figure 3)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
(Figure 4)
(continued)
22736 Rev A
Loading...