Hubbardton Forge 208226 User Manual

Installation Instructions B46

CAUTION: FAILURE TO INSTALL THI S FIXTURE PROPERLY MAY RESULT I N SERIO US PERSO NAL

Figure 1

Wall Sconces 203061, 203062, 203063 & 208226 Page 1 of 2

INJURY OR DEATH AND PROPERTY DAMAGE. We rec o mm e nd installation by a licensed electrician.

This product must be installed in accordance with applicable insta ll ati on co de(s ), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all

applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.

To Install (Figure 1)

Component Parts

A Bracket Assembly
B Machine Screw
C Fixture
D Machine Screw

Caution: Be sure power is off at the main breaker box
prior to installation.

1. Attach bracket assembly (A) to the electrical box

using two machine screws (not provided).

Note: A new electrical bo x comes with screws,
when replacing a fixture retain screws for use with
the new fixture.

2. Partially thread one machine screw (B) up

through the threaded hole in the top of the
mounting bracket leaving approximately 1/2" of
thread exposed.

3. Attach fixture wires to supply wires, black to

black and white to white. Connect all ground
wires to green ground screw in mounting bracket.

4. Place top hole in fixture back (C) over the screw

that is partially threaded through the top of the
bracket and secure by installing the second
machine screw (D) up through hole in bottom of
fixture back and into bottom of mounting bracket.

(continued)

Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735

16162 Rev B

Installation Instructions B46

Figure 2

Figure 3

Figure 4

Wall Sconces 203061, 203062, 203063 & 208226 Page 2 of 2

To Install Opaque Glass (Figure 2)

Component Parts

E Retaining Ring
F Glass
G Socket

1. Remove retaining ring (E) from socket (G). Retaining Rings are shipped installed.

2. Place glass (F) over socket (G).

3. Replace retaining ring (E) and tighten to secure glass. Do not over-tighten.

4. Install light bulbs.

5. Restore electricity at the main breaker.

To Install Water Glass (Figures 3 & 4)

Component Parts

E Retaining Ring
F Glass
G Socket
H Decorative Ring Cover

1. Remove retaining ring (E) from socket (G). Retaining Rings are shipped installed.

2. Install retaining ring (E) into decorative ring cover (H). If retaining ring (E) fits to

loose bend a few inside tabs of the decorative ring cover (H) (Figure 4).

3. Place glass (F) over socket (G).

4. Replace retaining ring (E) and tighten to secure glass. Do not over-tighten.

5. Install light bulb.

6. Restore electricity at the main breaker.

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735

16162 Rev B