Hubbardton Forge 207815 User Manual

Installation Instructions B291

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIO US PERSO NAL

(Figure 1)

Rook Sconce 20-7815 Page 1 of 2

INJURY OR DEATH AND PROPERTY DAMAGE. We rec o mm e nd installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.

After installation extra hardware and accessories are possible; our kits are used on multiple products and options.

To Install Fixture (Figure 1)

Component Parts

A Cross Bar
B Threaded Studs (2)
C Fixture
D Knurled Balls (2)

Caution: Be sure power is off at the main breaker box prior to installation.

1. Carefully unpack the fixture from the carton.

2. Using two machine screws (not provided) attach

cross bar (A) to the electric box using inside oval
holes to orient fixture.

Note: A new electric box comes with screws.
When replacing a fixture, retain the screws for use
with the new fixture.

3. Start threaded studs (B) into appropriate holes in

crossbar (A).

4. Using suitable wire connectors (not provided),

connect the fixture wires to the supply wires,
(white to white, black to black, bare copper or
green to bare copper or green). If the fixture is
wired with twin lead lamp cord, connect the ribbed
side to white, and the smooth side to black.

Caution: Make sure wire connectors are twisted
on securely and no bare wires are exposed.

5. Carefully tuck all wires behind the fixture. Place

fixture (C) over threaded studs (B) and tighten
firmly to mounting surface using knurled balls (D).

6. See next page for bulb and glass installation.

Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735

28296

(continued)

Installation Instructions B291

(Figure 2)

(Figure 3)

Rook Sconce 20-7815 Page 2 of 2

To Install Glass (Figures 2 & 3)

Component Parts

C Fixture
E Glass
F Bulb (Included)
G Socket
H Thumb Screw
I Wireway Tube

1. Install light bulb (G) into sock et (H). Be careful not to touch bulb with bare hands; oil from the hands will

dramatically reduce bulb life.

2. Slide glass (F) into fixture (C) aligning the slot in the glass towards the back of the fixture (C). Slide glass into

fixture until it rests on the wireway tube (J).

3. Tighten thumb screw (I) until snug. Be careful not to over tighten.

4. Restore electricity at the main breaker.

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735

28296