Hubbardton Forge 207675 User Manual

Installation Instructions B283

CAUTION: FAILURE TO INSTALL THI S FIXTURE PROPERLY MAY RESULT I N SERIO US PERSO NAL

(Figure 1)

Cavaletti Sconce 20-7675 Page 1 of 2

INJURY OR DEATH AND PROPERTY DAMAGE. We rec o mm e nd installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.

To Mount Fixture to Wall (Figure 1)

Component Parts

A Crossbar
B Threaded Stud (2)
C Knurled Balls (2)
D Fixture Assembly
E Ground Screw

Caution: Be sure power is off at the main breaker box prior to installation.

1. Carefully unpack the fixture from the carton.

2. Using two machine screws (not provided), fasten

the crossbar (A) to the electric box making sure
that fixture mounting holes are level.

Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture.

3. Thread studs (B) into the appropriate holes in the

crossbar (A). Adjust the studs to proper length to
ensure the fixture will fit snugly to the wall.

4. Hold the fixture assembly (D) close to the wall

and using suitable wire connectors, (not
provided), connect fixture wires to supply (white
to white or ribbed and black to black or smooth).
Run a pigtail lead from the crossbar ground screw
(E) and connect all ground wires (bare copper or
green to bare copper or green).

Caution: Make sure wire connectors are twisted
on securely, and no bare wire is exposed.

5. Slide fixture assembly (D) over threaded studs

(B) and push firmly to wall, making sure that no
wires are pinched between fixture back and wall.
Fasten with knurled balls (C). Be sure threaded
studs (B) are fully seated in the knurled balls (C).

6. See instructions on next page to install shade.

Hand-Forged, Vermont-Made Lighting a nd Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

28092

(continued)

Installation Instructions B283

(Figure 2)

Cavaletti Sconce 20-7675 Page 2 of 2

To Install Shade (Figure 2)

Component Parts

D Fixture Assembly
F Shade

1. Install light bulbs (not included).

2. Slip shade (F) onto fixture assembly (D) so it rests

against wall. It might be necessary to pull the
shade forward while sliding onto fixture. When
shade is correctly located you should feel it snap
into fixture assembly.

3. Restore electricity at main breaker.

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting a nd Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

28092