Hubbardton Forge 207663 User Manual

Installation Instructions B214

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL

(Figure 1)

Brindille Sconce 20-7660 & 20-7663 Page 1 of 2

INJURY OR DEATH AND PROPERTY DAMAGE. We rec o mm e nd installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

For fixtures requiring assembly, please refer to assembly instructions before installation.

Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.

To Mount Fixture to Wall (Figure 1)

Component Parts

A Crossbar
B Threaded Stud (2)
C Knurled Balls (2)
D Fixture Assembly
E Ground Screw

Caution: Be sure power is off at the main
breaker box prior to installation.

1. Carefully unpack the fixture from

the carton.

2. Using two machine screws (not

provided), fasten the crossbar (A) to
the electric box making sure that
fixture mounting holes are level.

Note: A new electric box comes
with screws. When replacing a
fixture, retain the existing screws for
use with the new fixture.

3. Thread studs (B) into the

appropriate holes in the crossbar
(A). Adjust the studs to proper
length to ensure the fixture will fit
snugly to the wall.

4. Hold the fixture assembly (D) close to the wall and using suitable wire connectors, not provided, connect fixture

wires to supply (white to white or ribbed and black to black or smooth). Connect all ground wires to ground
screw.

Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.

5. Slide fixture assembly (D) over threaded studs (B) and push firmly to wall, making sure that no wires are pinched

between fixture back and wall. Fasten with knurled balls (C). Be sure threaded studs (B) are fully seated in the
knurled balls (C).

6. See instructions on next page to install shade.

(continued)

Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735

24828

Installation Instructions B214

(Figure 2)

Brindille Sconce 20-7660 & 20-7663 Page 2 of 2

To Install Shade (Figure 2)

Component Parts

D Fixture Assembly
F Shade

1. Slip shade (F) onto fixture assembly (D) so

it rests against wall. It might be necessary
to pull the shade forward while sliding onto
fixture. When shade is correctly located
you should feel it snap into fixture
assembly.

2. Install light bulb.

3. Restore electricity at main breaker.

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735

24828