Hubbardton Forge 206741 User Manual

Installation Instructions B242

Forged Vertical Bars Sconce 20-6740, 206740F & 20-6741, 20-6741F Page 1 of 1

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.

To Mount Fixture to Wall and Install Glass (Figure 1)

Component Parts

A Crossbar
B Ground Screw
C Glass
D Spring Clip (2)
E Mounting Screw (2)

Caution: Be sure power is off at the main breaker box prior to installation.

1. Carefully unpack the fixture from the carton.

2. Using two machine screws (not provided), fasten the

crossbar (A) to the electric box making sure that
fixture mounting holes are level.

Note: A new electric box comes with screws. When
replacing a fixture, retain the existing screws for use
with the new fixture.

3. Hold the fixture assembly close to the wall and using

suitable wire connectors, not provided, connect
fixture wires to supply (white to white or ribbed and
black to black or smooth). Run a pigtail lead from
crossbar ground screw (B) to the junction box and
connect all ground wires (bare copper or green to
bare copper or green).

Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.

4. Push fixture assembly firmly to wall, making sure

that no wires are pinched between fixture back and
wall. Align mounting screws (E) with holes in
fixture back and thread into crossbar (A) until fixture
is tight against the wall.

5. Install light bulb. (GU24 included on F version)

6. Slide glass (D) between forged bars and spring clips

(E) until it bottoms out.

(Figure 1)

7. Restore electricity at main breaker.

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735

26948