Hubbardton Forge 206730 User Manual
Installation Instructions B81
Forged Vertical Bar 20-6729, 206729F & 20-6730, 20-6730F Page 1 of 1
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR
DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall & Install Glass (Figure 1)
Component Parts
A Glass F Ground Screw
B Top Adjusting Nut G Mounting Screw (2)
C Bent Bracket (top) H Bottom Adjusting Nut
D Textured Bar I Bent Bracket (bottom)
E Crossbar J Support Bar
Caution: Be sure power is off at the main breaker box prior to
installation
.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar
(E) to the electric box making sure that fixture mounting holes
are level.
replacing a fixture, retain the existing screws for use with the
new fixture.
Note: A new electric box comes with screws. When
3. Hold the fixture assembly close to the wall and using suitable
wire connectors, not provided, connect fixture wires to supply
(white to white or ribbed and black to black or smooth). Run a
pigtail lead from crossbar ground screw (F) to the junction box
and connect all ground wires (bare copper or green to bare
copper or green).
Caution: Make sure wire connectors are twisted on securely,
and no bare wire is exposed.
4. Push fixture assembly firmly to wall, making sure that no
wires are pinched between fixture back and wall. Fasten
fixture assembly to Crossbar (E) with mounting screws (G) until
(Figure 1)
the fixture is tight against the wall.
5. Install light bulb(s) (included on F version only)
6. Orient the two bent brackets to a horizontal position
7. Slide glass (A) down into fixture, positioned between the bent bracket (C & J) and textured bar (D), until it rests
on the support bar (K). It may be necessary to rotate one or both adjusting nuts clockwise for glass to fit.
8. Rotate bottom adjusting nut (I) counter clockwise until glass (A) is snug against textured bar (D). Do not over
tighten as glass may crack. Rotate top adjusting nut (B) counter clockwise until glass (A) is snug. Do not over
tighten
9. Restore electricity at main breaker
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
*
Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
19421
Loading...