Hubbardton Forge 206551 User Manual

Page 1
Installation Instructions B244
Suspended Half Cone Sconce 20-6551 & 20-6551F Page 1 of 1
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
Component Parts
A Glass D Ground Screw B Forged Bar E Mounting Screw (2) C Crossbar F Fixture Assembly
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the
crossbar (C) to the electric box making sure that fixture mounting holes are level.
Note: A new electric box comes with screws. When replacing a fixture, retain the existing screws for use with the new fixture.
3. Hold the fixture assembly (F) close to the wall and
using suitable wire connectors, not provided, connect fixture wires to supply (white to white or ribbed and black to black or smooth). Run a pigtail lead from crossbar ground screw (D) to the junction box and connect all ground wires (bare copper or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
4. Push fixture assembly firmly to wall, making sure
that no wires are pinched between fixture back and wall. Align mounting screws (E) with holes in fixture back and thread into crossbar (C) until fixture is tight against the wall.
5. Install light bulb (GU24 included on F version)
6. Slide glass (A) downward into fixture and adjust so
it is level and flush against the high point on the curve of the fixture (B).
(Figure 1)
7. Restore electricity at main breaker
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product. We hope you enjoy your fixture!
*
Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories 154 Route 30 South, Castleton, Vermont 05735
26950
Loading...