Hubbardton Forge 206032 User Manual

Fixture Assembly & Installation Instructions B44

Page 1 of 3

Component Parts

A Glass
B Oval Frame
C Retaining Clips
D Blinders
E Screws

To Install Glass in Frame

1. Remove retaining clips (C) from oval frame (B) making note of how they are attached to the frame. Depending on

the fixture style, there may be one or two clips. Note that there is a left clip and a right clip. The clips are slanted to
follow the edge of the glass.

2. Slide glass (A) into frame.

3. Keeping glass centered in frame, return clips to frame, slide inward so they grasp the edge of the glass and tighten

the screws to hold the clips in place.

4. Slide blinders (D) outward so the edge of the blinder is positioned just inside the outer edge of the glass, and secure

by tightening screws. The purpose of the blinders is to eliminate glare on the mounting surface.

5. Please refer to Fixture Installation Instructions on next page prior to attaching frame to fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

(continued)

16046 RevA

Fixture Assembly & Installation Instructions B44

Page 2 of 3

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all

applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.

Component Parts

A Crossbar
B Threaded Studs
C Fixture Back
D Threaded Balls

To Install Fixture

Caution: Be sure power is off at the main breaker box prior to installation.

1. Using two machine screws (not provided), fasten the crossbar (A) to the outlet box, making sure the mounting

holes are level.

with the new fixture.

Note: A new outlet box comes with screws. When replacing a fixture, retain the screws for use

2. Start threaded studs (B) into appropriate holes in

crossbar. This fixture may be mounted horizontally
or vertically as desired.

3. Using suitable wire connectors (not provided),

connect fixture wires to supply wires, white to white
and black to black. Connect all ground wires to
crossbar ground screw.

Caution: Make sure wire connectors are twisted on
securely, and that no bare conductors are showing.

4. Place fixture (C) over threaded studs and tighten

firmly to mounting surface using threaded balls (D).
To facilitate final assembly, we recommend
orienting the fixture such that the tapped hole in the
side of the fixture is oriented in the most
accessible direction. Final assembly will
require installation of a screw in this hole.

5. Install light bulbs.

Caution- Risk of Fire. This fixture is designed only for use with halogen bulbs marked “suitable for use in open
luminaries.” We provide and recommend Sylvania brand bulbs. The pictogram shown below indicates that a bulb

is suitable for use in open luminaries. Do not use replacement bulbs that do not display this marking.

(continued)

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

16046 RevA