Hubbardton Forge 205923 User Manual

Glass Installation Instructions B42

Page 1 of 2

Please refer to fixture assembly and installation instructions prior to glass installation.

Component Parts

A Glass
B Nylon Screw (fixtures using two pieces of glass only)
C End Cap
D Nut (3)

To Mount Glass to Frame

1. Slide Glass (A) into frame with one end snug against center divider.

2. For fixtures using one piece of glass, skip to step 5. For fixtures using two pieces of glass, tighten nylon screw (B)

against glass, keeping glass centered in the frame.

3. Insert studs on end cap (C) through holes in frame and secure with nuts (D) making sure glass remains centered in

frame. End cap should hold the glass securely in position, but do not over tighten the nuts.

4. For fixtures using two pieces of glass, repeat the process for the second piece.

5. For fixtures using one piece of glass, install the second end cap, making sure glass remains centered in the frame.

6. Refer to frame mounting instructions on the other side of this sheet to complete the installation.

(continued)

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

15647

Glass Installation Instructions B42

Page 2 of 2

Please refer to frame assembly instructions on the opposite side of this sheet prior to mounting frame.

Component Parts

A Frame
B Pin
C Ball Screw

To Install Frame/Glass

1. Attach frame assembly to fixture by positioning the frame over the light bulbs so that the pins (B) on the fixture

slide into the L shaped notches in the frame. For horizontal installation, the L shaped notches should be pointing
upward. For vertical installations, the L shaped notches may be pointing either left or right.

2. Secure the frame to the fixture by threading the ball screws (C) through the frame and into the fixture body. This

locks the frame in place. To change the light bulbs, simply back the ball screws out enough to remove the frame
from the fixture- it is not necessary to remove them completely.

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

15647