Hubbardton Forge 205892 User Manual

Installation Instructions B247

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

(Figure 1)

Banded Sconce 20-5812, 20-5812F & 20-5892, 20-5892F Page 1 of 1

DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the construction
and operation of the product and the hazards involved.*

Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all applications. If
installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.

To Mount Fixture to Wall and Install Glass (Figure 1)

Component Parts

A Glass D Crossbar
B Forged Band E Threaded Stud (2)
C Ground Screw F Barrel Kn ob (2)

Caution: Be sure power is off at the main breaker box prior to
installation.

1. Carefully unpack the fixture from the carton.

2. Using two machine screws (not provided), fasten the crossbar

(D) to the electric box making sure that fixture mounting
holes are level.

Note: A new electric box comes with screws. When
replacing a fixture, retain the existing screws for use with the
new fixture.

3. Thread studs (E) into the appropriate holes in the crossbar

(D). Adjust the studs to proper length to ensure the fixture
will fit snugly to the wall.

4. Hold the fixture assembly close to the wall and using suitable

wire connectors, not provided, connect fixture wires to supply
(white to white or ribbed and black to black or smooth). Run
a pigtail lead from crossbar ground screw (C) to the junction
box and connect all ground wires (bare copper or green to
bare copper or green).

Caution: Make sure wire connectors are twisted on securely,
and no bare wire is exposed.

5. Slide fixture assembly over threaded studs (E) and push

firmly to wall, making sure that no wires are pinched between
fixture back and wall. Fasten with barrel knobs (F). Be sure
threaded studs (E) are fully seated in the barrel knobs (F).

6. Install light bulb (GU24 included on F-version only)

7. Lower glass (A) into fixture between forged band (B) and

back of fixture until it contacts wireway.

8. Restore electricity at main breaker

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735

26953