Hubbardton Forge 205772L User Manual

Installation Instructions B225

Forged Leaf and Stem Sconce 20-5770L & 20-5770R Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

Caution: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all applications. If
installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.

Please Note: The hardware provided is intended for use in wood frame construction and may not be suitable for all

applications. If installing in non-wood frame applications, please consult a qualified builder to determine and obtain the
appropriate fasteners.

To Install Fixture (Figure 1)

Component Parts

A Cross Head Machine Screws (2) (Provided)
B Back plate
C Crossbar
D Ground Screw

Caution: Be sure power is off at the main
breaker box prior to installation.

1. Carefully unpack the fixture from the

carton.

2. Using two machine screws (not

provided), fasten the crossbar (C) to the
electric box (see illustration), making
sure that fixture mounting holes are

This illustration represents a typical

fixture and may not match every style.

level.

Note: A new electric box comes with
screws. When replacing a fixture, retain
the existing screws for use with the new
fixture.

3. Using suitable wire connectors (not

provided) connect fixture wires to
supply wires (white to white and black
to black). If the fixture is wired with
twin lead lamp cord, connect white to
ribbed side of the fixtures cord, black to
smooth side. Run a pigtail lead from
crossbar ground screw (D) to the

Figure 1

junction box and connect all ground
wires (bare copper or green to bare copper or green).

Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.

4. Once wires are connected securely line up holes in back plate with the threaded holes in the crossbar. Thread in

the two cross head machine screws provided until back plate is secured against wall.

5. Install light bulb(s) (not provided).

6. Install glass (see instructions below).

(continued)

Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735

26776

Installation Instructions B225

Forged Leaf and Stem Sconce 20-5770L & 20-5770R Page 2 of 2

To Attach Decorative Assembly & Acrylic To Back plate

Component Parts

B Back Plate
E Decorative Assembly
F Acrylic

(Figure 2)

1. Decorative assembly (E) will be shipped already installed to acrylic (F).

2. Attach decorative assembly (E) and acrylic (F) to back plate (B) by spreading the acrylic (F) apart wide enough to

insert the holes in the acrylic (F) over the two welded rods.

Figure 2

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735

26776