Page 1
Installation Instructions B250
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
Gothic Arches Sconce 20-5651 & 20-5651F Page 1 of 1
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall and Install Glass (Figure 1)
Component Parts
A Glass D Decorative Cage
B Ground Screw E Mounting Screw (2)
C Crossbar F Fixture Back
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar (C) to
the electric box making sure that fixture mounting holes are level.
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Hold the fixture assembly (F) close to the wall and using suitable
wire connectors, not provided, connect fixture wires to supply (white
to white or ribbed and black to black or smooth). Run a pigtail lead
from crossbar ground screw (B) to the junction box and connect all
ground wires (bare copper or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and
no bare wire is exposed.
4. Push fixture assembly firmly to wall, making sure that no wires are
pinched between fixture back and wall. Align mounting screws (E)
with holes in fixture back and thread into crossbar (C) until fixture is
tight against the wall.
5. Install light bulb (GU24 bulb included on F-version only)
6. Slide glass (A) downward slowly into decorative cage (D). Glass will stop once it rests on the base tabs.
Note: If you have difficulty sliding the glass behind the decorative cage on this fixture, the cage may have been
slightly bent during shipping. To install the glass, simply pull the decorative wire cage away from the backplate
allowing the glass to slide behind it.
7. Restore electricity at main breaker
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 26956
Loading...