Hubbardton Forge 205320 User Manual

Installation Instructions B268

Calla Sconce 20-5320 Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.

To Mount Fixture to Wall (Figure 1)

Component Parts

A Crossbar
B Threaded Stud
C Knurled Ball
D Fixture Assembly
E Ground Screw
F Cupped Washer

Caution: Be sure power is off at the main
breaker box prior to installation.

1. Carefully unpack the fixture from the

carton.

2. Using two machine screws (not

provided), fasten the crossbar (A) to the
electric box making sure that fixture
mounting holes are level. The crossbar
must be mounted with the tab centered
on the top and facing out.

Note: A new electric box comes with
screws. When replacing a fixture, retain
the existing screws for use with the new
fixture.

3. Thread stud (B) into knurled ball (C).

Be sure threaded stud (B) is fully seated
in the knurled ball (C).

(Figure 1)

4. Hold the fixture (D) close to the wall

and using suitable wire connectors, (not provided), connect fixture wires to supply (white to white or ribbed and
black to black or smooth). Run a pigtail lead from crossbar ground screw (E) to the junction box and connect all
ground wires (bare copper or green to bare copper or green).

Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.

5. Align fixture assembly (D) over crossbar (A) and push firmly to wall, making sure that no wires are pinched

between fixture back and wall. Slide threaded stud (B) down through fixture (D) and thread into crossbar (A).
Tighten until fixture (D) is snug against the wall. Be sure that the bottom tab on crossbar is aligned with the tab
on fixture (D).

6. See instructions on next page to install glass.

(continued)

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

27239

Installation Instructions B268

Calla Sconce 20-5320 Page 2 of 2

To Install Shade

Component Parts

G Socket
H Glass Spacer
I Retaining Ring
J Glass

1. To prepare fixture; remove glass spacer (H) and retaining ring (I) from socket (G) (spacer and ring ship

installed). Retain for later use (Figure 2).

2. Install light bulbs (not included).

3. Slip glass (J) and glass spacer (H) over socket (G). Thread retaining ring (I) onto socket and tighten against glass

spacer (H) (Figure 3).
Note: Be sure not to over tighten.

4. Restore electricity at main breaker.

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!

(Figures 2 & 3)

(Figure 2) (Figure 3)

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

27239