Hubbardton Forge 205315 User Manual
Installation Instructions B263
Calla Sconce with Shade 20-5315 Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Crossbar
B Threaded Stud (2)
C Knurled Ball (2)
D Fixture Assembly
E Ground Screw
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided),
fasten the crossbar (A) to the electric box
making sure that fixture mounting holes are
level.
Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture.
3. Thread studs (B) into the appropriate holes in
the crossbar (A). Adjust the studs to proper
length to ensure the fixture will fit snugly to
the wall.
4. Hold the fixture (D) close to the wall and
using suitable wire connectors, not provided,
connect fixture wires to supply (white to white
or ribbed and black to black or smooth). Run a
pigtail lead from crossbar ground screw (E) to
the junction box and connect all ground wires
(bare copper or green to bare copper or green).
Caution: Make sure wire connectors are
twisted on securely, and no bare wire is
exposed.
5. Slide fixture assembly (D) over threaded studs
(B) and push firmly to wall, making sure that
no wires are pinched between fixture back and
wall. Fasten with knurled balls (C). Be sure
threaded studs (B) are fully seated in the
knurled balls (C).
6. See instructions on next page to install shade.
(Figure 1)
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
27151
(continued)
Installation Instructions B263
Calla Sconce with Shade 20-5315 Page 2 of 2
To Install Shade
Component Parts
D Fixture Assembly
F Shade
1. Install light bulbs (not included).
2. Slip shade (F) onto fixture assembly (D) so it rests against
wall.
3. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
(Figure 2)
(Figure 2)
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
27151
Loading...